Table of Contents
Advertisement
Control guide
Preparing the remote control
Place this side in before the other side.
■ Batteries
•
Use a manganese dry battery or an alkaline dry battery.
•
Insert so the poles (+ and –) match those in the remote
control.
•
Remove if the remote control is not going to be used for a
long period of time.
•
Store in a cool and dark place.
•
Do not heat or expose to flame.
•
Do not leave the batteries in an automobile exposed to direct
sunlight for a long period of time with doors and windows
closed.
•
Mishandling of batteries in the remote control can cause
electrolyte leakage, which may cause a fire.
■ Do not:
•
mix old and new batteries.
•
use different types of batteries at the same time.
•
take apart or short-circuit the batteries.
•
attempt to recharge alkaline or manganese batteries.
•
use the batteries if the coverings have been peeled off.
(continued)
R6/LR6, AA
Disc operations
g Inserting a disc
Press [^] to turn the unit on.
Press [;, CD] to open the sliding door.
With the label of the disc facing towards you, tilt the disc
into the disc tray under the sliding door.
Place the disc onto the spindle in the centre and then
push the disc down until it clicks into place.
Click!
Press [;, CD] to close the sliding door.
Keep fingers away from the sliding door when it is closing to
avoid possible minor injuries.
g Removing a disc
Press [;, CD] to open the sliding door.
Hold the centre and the top right of the disc and pull the
top right of the disc to unlock it from the spindle.
Tilt the disc so as not to touch the sliding door and
remove the disc.
•
Damage may occur if the sliding door is forced closed.
•
Be careful of CD hitting the sliding door while being removed.
9
Hide quick links:
Advertisement
Table of Contents
