Menu Functions - Panasonic NV-DS12B Operating Instructions Manual

Menu Functions

Camera Functions Menu
1
CAMERA SETUP
D.ZOOM 40 400
CINEMA OFF ON
M.SENSOR OFF ON
RETURN ---- YES
PRESS MENU TO EXIT
3
CARD SETUP
PICTURE QUALITY
FINE NORMAL ECONOMY
RETURN ---- YES
PRESS MENU TO EXIT
The illustrations of the menus are intended for
explaining the functions; the actual menus look
somewhat different.
Camera Mode Main-Menu [CAMERA FUNCTIONS]
1. CAMERA SETUP
2. DIGITAL EFFECT
3. CARD SETUP (NV-DS25 only)
4. RECORDING SETUP
5. DISPLAY SETUP
6. OTHER FUNCTIONS
7. DEMO MODE
[CAMERA SETUP] Sub-Menu
Digital Zoom [D.ZOOM] (p. 31)
Cinema-like Format Recording [CINEMA]
(p. 32)
Motion-Sensor-Controlled Recording
[M.SENSOR] (p. 52, 54)
Returning to the Main-Menu [RETURN]
If you set [RETURN] to [YES], the Menu
changes back to the Main-Menu.
18
2
DIGITAL EFFECT
EFFECT1 OFF [&ZOOM [
ZOOM WIPE MIX
STROBE GAINUP
TRACER MOSAIC
MIRROR
EFFECT2 OFF NEGA SEPIA
B/W SOLARI
RETURN ---- YES
PRESS MENU TO EXIT
4
RECORDING SETUP
REC SPEED SP LP
AUDIO REC 12bit 16bit
SCENEINDEX 2HOUR DAY
WIND CUT OFF ON
ZOOM MIC OFF ON
RETURN ---- YES
PRESS MENU TO EXIT
[DIGITAL EFFECT] Sub-Menu
Digital Effects 1 [EFFECT1] (p. 48)
Digital Effects 2 [EFFECT2] (p. 48)
[CARD SETUP] Sub-Menu (NV-DS25 only)
Picture Quality [PICTURE QUALITY] (p. 69)
[RECORDING SETUP] Sub-Menu
Recording Speed Mode [REC SPEED] (p. 13)
Audio Recording Mode [AUDIO REC] (p. 64)
Scene Index Mode [SCENEINDEX] (p. 42)
Wind Noise Reduction [WIND CUT]
If you set [WIND CUT] to [ON], the noise of the
wind hitting the Microphone is reduced.
However, this also causes a slight deterioration
of the sound reproduction in the bass range.
Zoom Microphone [ZOOM MIC] (p. 31)
5
DISPLAY SETUP DISPLAY SETUP
DATE/TIME OFF TIME DATE
C.DISPLAY COUNTER MEMORY
TIMECODE
C.RESET ---- YES
DISPLAY ALL PARTIAL OFF
LCD MODE NORMAL BRIGHT
LCD/EVF SET ---- YES
RETURN ---- YES
PRESS MENU TO EXIT PRESS MENU TO EXIT
7
DEMO MODE
RETURN
PRESS MENU TO EXIT PRESS MENU TO EXIT
[DISPLAY SETUP] Sub-Menu
Date and Time Indication [DATE/TIME]
(p. 35)
Counter Display Mode [C.DISPLAY] (p. 99)
Counter Reset [C.RESET] (p. 97)
To reset the counter to zero.
However, the Time Code cannot be reset.
Display Mode [DISPLAY] (P. 99)
LCD Lighting Mode [LCD MODE] (p. 22)
(NV-DS15, NV-DS150, NV-DS25 only)
LCD and Viewfinder Adjustment [LCD/EVF
SET] (p. 22)
(LCD Monitor adjustment is only for models NV-
DS15, NV-DS150 and NV-DS25.)
[OTHER FUNCTIONS] Sub-Menu
Remote Controller Mode [REMOTE] (p. 83)
Recording Lamp [REC LAMP] (p. 25)
Beep Sound [BEEP SOUND]
(NV-DS15, NV-DS150, NV-DS25 only)
If you set [BEEP SOUND] to [ON], a
confirmation/alarm beep sound is emitted in the
following cases:
1 Beep
When you start recording
When you switch the [OFF/ON] Switch from
[OFF] to [ON]
2 Beeps
When you pause recording
10 Beeps
When you operate the Movie Camera in an
inappropriate way before or during recording
6
OTHER FUNCTIONS OTHER FUNCTIONS
REMOTE VCR1 VCR2 OFF
REC LAMP OFF ON
BEEP SOUND OFF ON
SHTR EFFECT OFF ON
CLOCK SET ---- YES
SELFSHOOT NORMAL MIRROR
RETURN RETURN ---- ---- YES YES
PRESS MENU TO EXIT PRESS MENU TO EXIT
DEMO MODE DEMO MODE
OFF ON
---- YES
Shutter Effect [SHTR EFFECT] (p. 31)
Date and Time Setting [CLOCK SET] (p. 23)
Self-Recording [SELFSHOOT] (p. 29)
(NV-DS15, NV-DS150, NV-DS25 only)
[DEMO MODE] Sub-Menu
Demonstration Mode [DEMO MODE]
If you connect the AC Adaptor to the Movie
Camera, set the [OFF/ON] Switch to [ON]
without any cassette inserted, and leave it on
for approximately 10 minutes without
performing any operation, the Movie Camera
automatically switches over to the
Demonstration Mode to show its functions.
Pressing a button or performing some other
operation suspends the Demonstration Mode.
Leaving the Movie Camera again on for more
than 10 minutes without operating it, causes the
demonstration to start again.
Also, when you set [DEMO MODE] to [ON] and
then exit the menu, the demonstration starts.
To cancel the Demonstration Mode, insert a
cassette or set [DEMO MODE] to [OFF].
19