For Heat Pump Type; Soft Dry Operation Mode; Auto Operation Mode (Cooling Type) - LG Air Conditioner Owner's Manual

For Heat Pump Type

5
This air-conditioner is set to the hot start control in order not
to discharge the cold air during the heating operation. This
time, the remote controller indicates 'Preheat'.
6
If the outdoor temperature is too low during the heating
operation, this air-conditioner is set to the defrosting
operation and the remote controller indicates 'Defrost'.

Soft Dry Operation Mode

7
Soft Dry Operation is used to remove the humidity softly without overcooling the room, specially when the
humidity is already low.
The indoor fan speed is automatically set to the low. But you can change it. Soft dry operation cancels and
becomes the cooling operation if you press the operation mode selection button.

Auto Operation Mode (Cooling Type)

8
The temperature and fan speed are automatically set by the electronic controls based on the actual
room temperature. If you want to change the set temperature, close the door on the remote control and
press the Room Temperature Setting buttons. The cooler or warmer you feel, the more times
(up to two times) you should press the button. The set temperature will then be changed.
The temperature can be set within a range of -2~2 by 1 level.
AUTO SWING OPERATION
Timer Operation unit
On Off
Set no. Time 01 03 05 07
(This indication will be shifted to the initial
Auto Mode Display state after 5 seconds.)
During Auto Operation:
❏ You cannot switch the indoor fan speed. It has already been set by the Fuzzy rule.
❏ If the system is not operating as desired, manually switch to another mode. The system will not
automatically switch from the cooling mode to the heating mode, or from heating to cooling, it must be
done by manually resetting.
❏ During Auto Operation, pressing the chaos swing button makes the horizontal louvers swing up and
down automatically. If you want to stop auto-swing, press the chaos swing button again.
SET TEMP FAN SPEED SUB FUNCTION
Room Temp
HI AUTO Heater Preheat
MED JET Defrost Humidify
LO Filter Out door
Time ZONE 1 2 3 4
Program set
09 11 13 15 17 19 21 23
AUTO SWING
Timer
On Off
Set no. Time
AUTO SWING
Timer
On Off
Set no. Time
Cold Cool Proper Warm Hot
To raise the Temperature.
To lower the Temperature.
Operating Instructions
OPERATION SET TEMP FAN SPEED SUB FUNCTION
Room Temp
HI AUTO Heater
MED JET Defrost
LO Filter
Time ZONE 1 2 3 4
Operation unit Program set
01 03 05 07 09 11 13 15 17 19 21
OPERATION SET TEMP FAN SPEED SUB FUNCTION
Room Temp
HI AUTO Heater
MED JET Defrost
LO Filter
Time ZONE 1 2 3 4
Operation unit Program set
01 03 05 07 09 11 13 15 17 19 21
Owner's Manual 13
Preheat
Humidify
Out door
23
Preheat
Humidify
Out door
23