Other Programming Selections; Data Format Editor Commands - Hand Held Products 3800 User Manual

Note: The wildcard for all terminal types is 099.
Step 4. Code I.D.
On page
format. Locate the Hex value for that symbology and scan the 2 digit
hex value from the Programming Chart.
Step 5. Length
Specify what length (up to 9999 characters) of data will be acceptable
for this symbology. Scan the four digit data length from the Program-
ming Chart. (Note: 50 characters is entered as 0050. 9999 is a univer-
sal number, indicating all lengths.)
Step 6. Editor Commands
Refer to the Format Editor Commands Chart
bols that represent the command you want to enter. 94 alphanumeric
characters may be entered for each symbology data format.
Step 7. Scan Save to save your entries.

Other Programming Selections

• Clear One Data Format
This deletes one data format for one symbology. If you are clearing the
primary format, scan 0. If you are clearing an alternate format, scan 1, 2, or
3, depending on the alternate format you are clearing. Scan the Terminal
Type (refer to the Supported Terminals Chart on
length of the format you want to delete. That length data format for that
symbology is deleted and all other formats are unaffected.
• Save
This exits, saving any Data Format changes.
• Discard
This exits without saving any Data Format changes.

Data Format Editor Commands

Send Commands
F1 Send all characters followed by "xx" key or function code, starting from cur-
rent cursor position. Syntax = F1xx (xx stands for the hex value for an
ASCII code, see Decimal to Hex to ASCII Conversion chart,
F2 Send "nn" characters followed by "xx" key or function code, starting from
current cursor position. Syntax = F2nnxx (nn stands for the numeric value
(00-99) for the number of characters and xx stands for the hex value for an
ASCII code. See Decimal to Hex to ASCII Conversion chart,
F3 Send up to but not including "ss" character (Search and Send) starting from
current cursor position, leaving cursor pointing to "ss" character followed by
"xx" key or function code. Syntax = F3ssxx (ss and xx both stand for the
hex values for ASCII codes, see Decimal to Hex to ASCII Conversion chart,
page 4-6.)
5 - 2
4-5, find the symbology to which you want to apply the data
(page 5-2). Scan the sym-
page 2-3), Code I.D. and the
page
page
3800/3900 User's Guide
4-6.)
4-6.)