General functions
Key lock
In order to prevent changing the settings unintention-
ally by touching the buttons, you can activate the
key lock.
•
Press and hold down the
3 seconds. The screen will flash
SNOOZE
tons except the
•
Press and hold down the
about 3 seconds to cancel the key lock. The
message on the screen disappears.
Screen lighting
•
Press any button to illuminate the screen.
The screen will remain lit for about 10 seconds.
Stand
•
Flip out the stand on the rear of the device
to enable it to stand more stably.
Time functions
The time functions can only be set when the radio is
switched off. If the time cannot be set using the RDS
signal, the default time of the world receiver starts at
0:00 00.
The settings are lost if the device is disconnected
from its power supply.
Time, date, time zone and world time
MODE
You can use the
button to set the time, date
and time zone, query the world time and set the
date alarm, medium wave reception, alarm time
reception, hourly mode and time update.
MEM
button for around
. All but-
button are now locked.
MEM
button again for
MODE
When you press
for about 15 seconds. During this time, adjust the
UP/DOWN
setting with the
MODE
•
Press
x 1: Set clock time.
MODE
•
Press
x 2: Set the date.
MODE
•
Press
x 3: Set time zone
(„Local city").
MODE
•
Press
x 4: Show world time.
MODE
•
Press
x 5: Date alarm.
MODE
•
Press
x 6: Set reception range for
medium wave.
MODE
•
Press
x 7: Set alarm pause.
MODE
•
Press
x 8: Set 12/24 hour mode.
MODE
•
Press
x 9: Set automatic time query.
To apply a setting, just wait until the screen stops
flashing (the screen reverts to the time indication)
MODE
or press
to move on to the next function.
Setting clock time
MODE
•
Press
once. The most recently set time
flashes on the screen.
UP
•
Press the
or
forward or backward at minute intervals.
Hold down one of the buttons for a few
seconds to move the setting forward or
backward quickly at 10 minute intervals.
Note:
Set the time without summer time offset.
If summer time is required, this can be set
when setting the time zone (see below).
- 6 -
, the function to be set flashes
buttons.
DOWN
button to move the time