Insert a screwdriver into the screw hole and push the optical drive. Pull the optical drive out.
1050 Memory modules
For access, remove these FRUs in order:
•
"1010 Battery pack" on page 44
•
"1020 Bottom slot cover" on page 44
Removal steps of memory modules
Release the two latches on both edges of the socket at the same time in the direction shown by the arrows
1
, and then unplug the DIMM in the direction shown by the arrow
Note: If only one memory module is used on the computer you are servicing, the card must be installed in
SLOT-0 (
a
: lower slot), but not in SLOT-1 (
48
Hardware Maintenance Manual
b
: upper slot).
2
.