Working With The Cutting And Grating Discs; Working With The Kneading Blade; Working With The Blender - Bifinett KH 700 Operating And Safety Instructions Manual

7.2 Working with the cutting and
grating discs
Caution: The cutting edges are very sharp!
Be particularly careful when inserting and
removing or cleaning the discs!
Never use your fingers, spatula, spoon han-
dles or similar objects for pushing foodstuff
through the filling shaft!
With the cutting and grating discs you can
quickly slice or grate ingredients. The special
chip disc allows you to quickly prepare
homemade chips. With the potato pancake
disc you can grate raw potatoes for the
dough but also grate other vegetables or fruit
finely.
• Fit the mixing bowl on
the food processor.
S • Select the appropriate
disc. Insert the disc
with the guide edge
(the side without mark-
ing) in the disc holder.
• Push the other side
(marked with two circles
at the corners) down
until the disc engages
with a "click".
8
• Fit the retainer to the
drive shaft. Insert thumb
and index finger in the
holes of the disc holder
and place it on the
retainer.
• Place the lid on the
bowl.
• You can now fill ingre-
dients through the filling
shaft.
• For cutting and grating
set the speed controller
to speed 3 (maximum
speed). Should you wish to process soft fruit
or vegetables you can also select a lower
speed. Slowly and gradually push the ingre-
dients in the filling shaft using the pusher.
• To remove the disc from
the disc holder, remove
the disc from the disc
holder by pushing on
the marked side in an
upward direction.
Hints:
• Cut the food into pieces so that they fit
through the filling shaft.
• Fill the filling shaft evenly and do not exert
excessive pressure.
• If you wish to process large quantities of
food do it in small batches and empty the
mixing bowl in-between.
7.3 Working with the kneading
blade
With the kneading blade you can knead
bread dough and mix batter or cake mixture.
• Place the mixing bowl
on the food processor.
• Place the kneading
blade on the retainer
and fit on the drive
shaft.
• Add the ingredients to
the mixing bowl.
• Place the lid on the
bowl and the pusher in
the filling shaft. Set the
speed controller to the
speed recommended in
the Table.
Hints:
• Put liquid ingredients into the bowl last and
start mixing at low speed to avoid splash-
ing.
• Never fill the mixing bowl above the MAX.
mark (1.5l).
• For mixing "water like" liquids only use the
speed 1 with volume less than 1 l to avoid
liquid spilling out.

8 Working with the blender

Caution
• Never switch on the blender when empty.
• Never insert the plug in the socket before
the blender jug and the blender lid have
been correctly assembled.
• Always pull the plug from the socket
before removing the blender jug.
• Do not fill ingredients hotter than 80°C in
the blender jug.
• To avoid splashing, never add more than
1.5l of liquid in the blender jug.
• Never remove the blender lid during oper-
ation.
• First remove the blender lid before remov-
ing the blender jug.
• Never run the blender continuously for
more than 3 minutes.
You can use the blender to finely puree and
mix ingredients. You can use the blender for
preparing soups, sauces, milkshakes, baby
food or process vegetables and fruit into a
puree.
• First remove the cover
for the motor block by
turning it clockwise.
9