Figure 1 - Krell Industries PHANTOM II Owner's Reference Manual

(SECTION FOUR: Anatomy of an Phantom II continued)
Front Panel Description
See Figure 1 on the previous page
The Phantom II Preamplifier front panel functions are described below:
Chassis
Preamplifier Chassis
The preamplifier front panel provides power on, input and zone selection, level
control, menu functions, and status display.
Power Supply Chassis
Powerful transformers, high quality regulators, and extensive electrical and
magnetic shielding are housed in a separate power supply.
Power
1 Power Button or Key
Use this button or key to switch the Phantom II between the stand-by and
operational modes.
7 Stand-by/Power LED
The preamplifier LED illuminates red (stand-by) when the Phantom II is plugged
into a standard AC wall receptacle. It illuminates blue (operational mode) when
the power button (1) is pressed while the Phantom II is in stand-by mode.
Remote Functions on the Front Panel
2 Infrared Emitter
The stand-by/Power LED (7) flashes when the Phantom II sends signals via
this infrared emitter to a programmable remote control. See IR Out Control,
on page 37.
4 Infrared Sensor
The infrared sensor receives commands from the Phantom II remote control.
For proper remote control operation, make sure the infrared sensor is not cov-
ered or obstructed.
16