Connecting The Speakers; Installation Of Speakers - Kenwood CORE-A55 Instruction Manual

Installation of the main unit
How to use the horizontal installation cushions
●
Attach the cushions on the four positions on the bottom
of the main unit. Make sure that the cushion surfaces
contact the surface on which the main unit is installed. See
the following illustration for the positions of the cushions.
(8 cushions are provided with the system. Retain the
remaining 4 cushions for possible future use.)
How to use the vertical installation stand
●
When installing the main unit vertically, place it
lengthwise so that the SD card slot comes at the bottom.
Secure the main unit on the stand by tightening the
stand securing screw on the rear of the stand.
If the securing screw is too tight to remove, use a
●
commercially available fl at-blade screwdriver.

Installation of speakers

How to use the speaker stands
●
Install each speaker on each speaker stand so that
the arrow on the bottom of the stand points toward
the front. Each speaker can be adjusted at a desired
upward angle between 0° (vertical) and 20°.
Front side
Cushions

Connecting the speakers

How to attach the speaker terminal covers
●
Before connecting each speaker cord, pass the cord
through the hole on the provided speaker terminal
cover. After connecting the speaker cord to the
speaker, fi t the cover on the terminal.
How to prepare the speaker cord extremity
●
Remove the vinyl coating on the tip of each cord by
twisting the coating.
How to connect the speaker cord
●
How to remove the speaker terminal covers
●
Push down the hole on the speaker terminal cover and
remove it.
Be careful not to short-circuit the + and – conductors of
●
the speaker cord (be sure to avoid contact between the
+ and – conductors). If the speaker cord is connected
by inverting the + and – polarity, the reproduced audio
will be unnatural with unclear positioning of musical
instruments.
9
English