Table of Contents
Advertisement
6.1 List of error messages
The error messages that are displayed on the T-PSV screen are listed below.
Message
Baudrate setting is not correct.
Baudrate must be 1200,2400,4800,
9600,or 19200.
Connection Name is 11 characters or
less.
Connection setting and PLC setting are
required before TAG setting.
Connection setting is required before
PLC setting.
Connection setting is required before
Serial setting.
Continuous Register Tag cannot be
used for Device (Bit-data).
Continuous Register Tag must be
started with 'TA'.
Continuous Register Tags and
Individual Tags cannot be used
simultaneously for one PLC in High-
speed cycle.
Continuous Register Tags and
Individual Tags cannot be used
simultaneously for one PLC in Low-
speed cycle.
Continuous Register Tags and
Individual Tags cannot be used
simultaneously for one PLC in Middle-
speed cycle.
Cycle error.
Data length setting is not correct.
Data length must be 8.
In the serial setting, invalid baudrate is designated.
Designate any of 1200, 2400, 4800, 9600, or 19200.
In the connection setting, a connection name of more than 11
characters is used.
Modify the connection name within 11 characters.
In the configuration file, Tag setting is appeared before
connection or PLC setting.
The connection and PLC settings are required before Tag
setting.
In the configuration file, PLC setting is appeared before
connection setting.
The connection setting is required before PLC setting.
In the configuration file, serial setting is appeared before
connection setting.
The connection setting is required before serial setting.
In the Tag setting, Device (bit-data) is designated as
continuous address Tag.
Use Register for the continuous address Tag.
In the Tag setting, the starting address Tag is missing.
The starting address Tag (TA) is necessary.
In the Tag setting, continuous address Tags and individual
address Tags are designated for one PLC in High-speed cycle.
Use either one.
In the Tag setting, continuous address Tags and individual
address Tags are designated for one PLC in Low-speed cycle.
Use either one.
In the Tag setting, continuous address Tags and individual
address Tags are designated for one PLC in Middle-speed
cycle.
Use either one.
UDP thread control becomes incorrect.
In the serial setting, data bit length is designated other than 8.
Designate the data bit length as 8.
6. List of Error Messages
Contents
Operation Manual
29
Advertisement
Table of Contents
