Example Of Installation On The Floor Mat Or On The Chassis; Replacing The Terminal Cover; Changing The Direction Of The Badge - Pioneer Premier PRS-A900 Owner's Manual

Installation
Example of installation on the floor
mat or on the chassis
Replacing the terminal cover
2. Drill 2.5 mm (1/8 in.) diameter holes
at the point marked, and install the
amplifier, either on the carpet or
directly to the chassis.
1. Place the amplifier where it is to be
installed. Insert the supplied tap-
ping screws (4 mm x 18 mm) into
the screw holes. Push on the screws
with a screwdriver so they make
marks where the installation holes
are to be located.
Screw
/ Terminal Cover
l-L
I
Changing the Direction of the Badge
2. Tighten the screw with a 4 mm
hexagonal wrench.
1. To remove the badge, loose screws
by using a 2 mm hexagonal wrench.
2. Change the direction of badge, and
then tighten the screws with a
hexagonal wrench.
1. Align the unit and terminal cover,
and insert the screw.
;' .. l
Drill a 2.5 mm (1/8 in.)
diameter hole
Tapping screw .
(4 mmxJ8mm)
I.
Floor mat or chassis
Screw
- - - i
•