AM (MW) antenna connections
AM
EXT
AM
LOOP
FM 75
COAXIAL
ANTENNA
2
1
Outdoor single vinyl-covered wire (not supplied)
Turn the loop until you have the best reception.
Notes:
• If the AM (MW) loop antenna wire is covered with
vinyl, remove the vinyl by twisting it as illustrated.
• Make sure the antenna conductors do not touch any
other terminals, connecting cords and power cord.
This could cause poor reception.
• If reception is poor, connect an outdoor single vinyl-covered wire
(not supplied) to the AM EXT terminal. Keep the AM (MW) loop
antenna connected.
You can connect five speakers (a pair of front speakers, a center
speaker, and a pair of surround speakers) and a subwoofer.
AM (MW) Loop
CAUTIONS:
Antenna (supplied)
• Use only the speakers of the SPEAKER IMPEDANCE
• Do not connect more than one speaker to each speaker
Connecting the speakers
Snap the tabs on the loop
into the slots of the base
to assemble the AM
(MW) loop antenna.
3
1 Twist and remove the insulation at the end of
2 Press and hold the clamp of the speaker terminal
3 Insert the speaker cord.
4 Release the finger from the clamp.
Connecting the Speakers and Subwoofer
indicated by the speaker terminals.
terminal.
1
2
each speaker cord.
For each speaker (except for a subwoofer), connect the (+) and
(–) terminals on the rear panel to the (+) and (–) terminals
marked on the speakers.
To center speaker
To right front speaker
To right surround speaker
3
4
To left
front speaker
To left surround
speaker
5