Heater Lamp; Thermostat Operation - LG Window-Type Air Conditioner Owner's Manual

Controls
The controls will look like one of the following.
Thermostat
Warmer Cooler
Thermostat
• AUTO SWING (for some models)
ON ( ) : Air swing is operated while OPERATION
knob is set to the COOL or HEAT position.
OFF ( ) : Stops the operation of air swing.
FAN
Operation
Heater
Operation
• THERMOSTAT
Turn the thermostat control to the desired
setting. The control position is a normal setting for
average conditions. You can change this setting, if
FAN
necessary, in accordance with your temperature
preference.
The thermostat automatically controls cooling or
heating, but the fan runs continuously
whenever the air conditioner is in operation. If the
room is too warm, turn the thermostat
control clockwise. If the room is too cool, turn the
thermostat control counterclockwise.
• HEATER (
When the unit sets heating operation condition, the
green lamp is lighted.
When the frost settles on the heat exchanger of the
outside, defrosting is made automatically and the
green lamp is turned off.
The unit may give a "hiss" and the fan motor stops for
1 to 10 minutes.
This should not be regarded as a problem.
After defrosting, the heating operation begins again.
• OPERATION
OFF
LOW FAN
LOW COOL (
HIGH COOL (
LOW HEAT (
HIGH HEAT (
CAUTION
When the air conditioner has been performed
its cooling operation and is turned off or set to
the fan position, wait at least 3 minutes before
resetting to the cooling operation again.
8
) LAMP
o
( ) : Turns the air conditioner off.
( ) : Permits the low fan speed
operation without cooling
(heating).
) : Permits cooling with the low fan
speed operation.
) : Permits cooling with the high
fan speed operation.
) : Permits heating with the low
fan speed operation.
) : Permits heating with the high
fan speed operation.