Hamilton Beach 840101300 Use & Care Manual page 3

840101300 ENv02.qxd 5/10/02
To Steam Iron
1. Unplug iron. Using a cup, slowly pour 4 ounces (
tap water into water tank opening. Do not fill iron directly
from faucet.
2. Plug iron into outlet. Set Adjustable Steam Switch to STEAM.
3. Turn Temperature Control Dial to desired fabric setting in
steam range. Allow two minutes for the iron to reach desired
temperature.
4. To turn iron off, set Adjustable Steam Switch to 0 (Dry Iron).
Turn Temperature Control Dial to Off. Unplug iron.
5. Empty water from iron following directions in "Caring for
Your Iron."
Features
Auto Shutoff Reset Button/Light
The light comes on when the iron is first
plugged in even if Temperature Control
Dial is set at Off. The light indicates that
the iron is plugged in. After 15 minutes,
the iron will shut off and the light will
blink. Push the Reset Button to turn the
iron back on.
11:22 AM Page 4
1 ⁄ cup) of
2
Reset
Button
Light
4
Features
(cont.)
Power On Light
This light comes on when the iron is
plugged in and remains on until the iron
is unplugged. The light stays on even if
Temperature Control Dial is turned to Off.
Adjustable Steam Switch
This switch provides continuous steam
in the STEAM position. Push the switch
to 0 to change to dry iron.
Spray and Blast of Steam Buttons
Push spray button to release a fine spray
of water for difficult wrinkles in cotton or
linen. Push blast button for an extra blast
of steam.
Power
Light
Blast of
Spray
Steam
5