KitchenAid KDRU767VSS04 Installation Instructions Manual page 17

6.
Insert the small grease tray all the way under the front of the
grill basin and hook it into the slots.
When the 2 grease trays are installed properly, the small
grease tray will hook over the large grease tray.
7=
D
A. Large grease tray
B. Grease tray connection
C. Small grease tray
D. Slots
Insert the orifice tube on the front of the burner assembly into
the opening at the front of the grill basin and set burner
assembly into place.
A. Front opening
8.
Insert front tabs of the flame spreader into slots at the front of
the grill basin, then the rear tabs into the rear slots.
B
........................ A
A. Front tabs and slots
B. Rear tabs and slots
9. Check the surface burner and grill flames. Refer to the
"Electronic Ignition System" section.
10. Place the wave tray on top of the flame spreader.
The griddle is factory installed.
1. Place drip tray in the well at the front of the griddle. Slide tray
toward the back until it stops.
A
A. Griddle drip tray
B. Griddle
2. Clean griddle before using. Refer to the Use and Care Guide.
Install Burner Heads and Caps
Install the burner base, making sure the igniter electrode is
properly aligned with the base. Place burner caps on top of
burner bases. If burner caps are not properly positioned, surface
burners will not light.
20,000 Btulh Ultra Power
TM
Dual-Flame
Burner
A
A. Incorrect
B. Correct
15,000 Btu/h Professional Burner
A. Incorrect
' B. Correct
........................................... _1ii ; i.]i_l_l! F ...........................................
5,000 Btu/h Simmer/Melt Burner
/ _
A. Incorrect
-:,, ,:=:. g. Correct
11. Place the grill grate into position.
17