KitchenAid KDRU707VSS01 Installation Instructions Manual page 18

30", 36", 48" commercial style dual fuel convection range
Hide thumbs Also See for KDRU707VSS01:
Table of Contents

Advertisement

Available languages

Available languages

Initial Lighting and Gas Flame Adjustments
Cooktop burners use electronic igniters in place of standing
pilots. When the cooktop control knob is turned to any position,
the system creates a spark to light the burner. This sparking
continues until the flame is lit or the knob is turned to Off.
Check Operation of Cooktop Burners
Push in and turn each control knob to the "LITE" position.
The surface burners and grill flames should light within
4 seconds. The first time a burner is lit, it may take longer than
4 seconds to light because of air in the gas line.
After verifying the proper burner operation, turn the control knobs
to OFF.
If burners do not light properly:
Turn cooktop control knob to the "OFF" position.
Check that the range is plugged in and the circuit breaker has
not tripped or the fuse has not blown.
Check that the gas shutoff valves are set to the "open"
position.
Check that burner caps are properly positioned on burner
bases.
Repeat start-up. If a burner does not light at this point, contact
your dealer or authorized service company for assistance.
Flame Height
The cooktop flame should be a steady blue flame approximately
1_" (0.64 cm) high.
Dual Flame Burner
A. Upper flame
B. Lower (simmer) flame
Single Flame Burner
4. Open the oven door and remove the 2 screws on each side of
the range that hold the control console in place.
5.
NOTE: Make sure to leave oven door open or the control
console will not rest in the side brackets properly once it is
detached.
Pull up on the control console and let it drop forward into the
notched console brackets on each side.
6.
7.
;4
A. Control console bracket
Remove the round gasket from the valve stem.
Put a control knob onto the valve stem of the burner you want
to adjust.
To Adjust Flame Height:
1. Unplug range or disconnect power.
2. Remove burner grates.
3. Remove the control knobs.
8. Turn the control knob to LO and using a butane extension
lighter, light the burner.
9. Remove the control knob.
18

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kdru767vss01Kdrs407vss01Kdrs467vss01

Table of Contents