Advertisement
Available languages
Available languages
2.
Remove 5 screws (2 each side and above GFCI) holding the
metal front panel and remove panel.
front panel
3. Remove terminal box screw and terminal box.
4.
5.
6.
terminal box -
screw
terminal
box
Remove power cord green ground wire from under green
ground screw.
Remove twist-on connectors and disconnect black and white
wires. Do not reuse connectors.
' .....
do notremove this
_
'/"
grommet
power
cord
!
\
\
green ground wire
green ground screw
Use pliers and squeeze locking tab in the power cord strain
relief grommet.
7. Remove power cord and grommet.
8. install a CSA-certified,
U.L- or C-U.h-listed
conduit
connector in power cord hole.
Electrical
Shock Hazard
Electrically
ground
dishwasher.
Connect
ground
wire
to green
ground
connector
in
terminal
box.
Do not use an extension
cord.
Failure to follow
these instructions
can result indeath,
fire, or electrical
shock.
10. Route direct wire through conduit and connect wires as
follows:
[] Form ground wire into a hook and wrap clockwise around
ground screw under washer. Tighten ground screw
securely.
direct wire
ground wire
1_
green ground
screw
[] Use twist-on connectors of proper size to connect direct
wire to 16-gauge wire dishwasher wiring. Connect black
wires together and white wires together.
11. Reinstall terminal box.
IMPORTANT: The tabs must be under the terminal box as
shown.
terminal
tabs
9. install conduit.
Advertisement
