Advertisement
Available languages
Available languages
K_DS36 Product dimensions
SiDE
FRONT
water inlet
valve
5-25/32"
(14_7cm)
1-3/4" (4A cm)
i_ ----
to center of single
hole faucet
- dishwasher
drain
p,
.
.
I
10-7/8" (27 5 cm)
insTtail_e°drYair
po
center of'single
gaps
"--,._
ho'efaucet
_
8 _
(20.3 cm)
34-1/2" (87,6 cm)
}_,
I
5 1/2 ft (1 7 m)
_
"_
3-prong ground-type
!
_
14" (35,6 cm)---_
_
!
power supply cord
_
18-5/16"
(46.5 cm)
33-11/16" (85,6 cm)
_-
(between clamp rails)
t
19-3/8"
(49.2 crn)
maximum
opened lid
height
K_DS36 Cab{net requirements
*NOTE: The cutout must be accurately cut to the dimensions shown within
1/16" (1.6 mm). Dishwasher top flange overlaps the countertop cutout
by 7/16" (1.1 cm) on front and back edges and 1/4" (6.4 mm) on sides.
Cabinetry and countertop must be sturdy enough to support loaded
dishwasher and sink (400 Ibs. [181.4 kg]).
acksplash
7/16" (1,1 cm) rain.
flat surface required
21-1/8"
(53.7 cm)
(see *NOTE)
It is recommended
that sink
water and drain line
connections
be located on
this side of cabinet,
fer base cabinet
installations, rain. 36"
(91,4 cm) width required
25" (63.5 cm) deeF
countertop
.._Countertop
must be
levek
It is recommended
that dishwasher
water
and drain line
connections
be
located on this side
of cab net,
I
/
IMPORTANT: Corner radius dimensions
specified must be used. if they are not,
the dishwasher will not fit the opening.
_1 radius: 2-1/4" (5.7 cm)
radius: 1" (2.5 cm) -the
right back corner must be
cut to this radius
Back right corner: if countertop is
more than 3/4" (1.9 cm) thick,
measure down 3/4" (1.9 cm) and cut
45 ° bevel all the way around radius.
Advertisement
