The Control Panel - Hoover 6+4 Kg Wash'n dry Sensor Instruction Book

40002476.qxd 21/02/2005

The Control Panel

COUNTDOWN Display
START/
PAUSE
The programme
selector must be return
to the OFF position to
reset the controls
between each wash
cycle.
To start another wash
cycle the programme
selector must be
returned to OFF once
again before the next
programme can be
selected and started.
16
13:19 Page 16
TEMPERATURE
OPTIONS
BUTTONS SELECTOR
Turning the machine On
Turn the machine ON by selecting a programme using the
programme selector. This status will be indicated by the STOP
indicator light flashing, this light will continue to flash until
the machine has started or the machine is returned to the OFF
position.
Start/Pause
START
After selecting the programme and the required options (see
the Wash and Dry Options section of this manual) press the
START/PAUSE button once to start the cycle. The STOP light
will stop flashing and START light will illuminate and there will
be a short time delay to the start of the programme while the
machine sets the wash parameters for the selected programme
and options. If the duration of the programme you have
selected is shorter than 60 minutes, then the time remaining
indicator will illuminate accordingly. The door lock indicator
light will also illuminate a few seconds after pressing the
START/PAUSE button.
PAUSE
The programme may be paused at any time during the wash
cycle by holding down the START/PAUSE button for about two
seconds. When the machine is in the paused mode, the time
remaining for the programme in the COUNTDOWN indicator
and option buttons will flash. The door lock indicator light will
remain illuminated for approximately 2 minutes. The door can
PROGRAMME
DRYING TIME
SELECTOR SELECTOR