Kyocera Mita DP-2800 PLUS Instruction Handbook Manual page 180

Table of Contents

Advertisement

Chapter 5 Troubleshooting
5-16
Message
MEMORYCARD err ##
Press CONTINUE
Corrective Action
This message appears when an error occurs during access to the memory
card using the PRESCRIBE 2e RWER (ICCD) command or from the printer's
control panel. Look at the error code given in place of ## and refer to the
corresponding description given below. Note that only error codes 09 and 11
are displayed due to memory card operations made from the control panel.
01:Data or memory card capacity is too large.
·
This error code appears if an attempt is made to write more than
32 MB of data to a memory card or if the capacity of the memory card
installed in the printer is more than 32 MB. Decrease the data being
written to the memory card to less than 32 MB. Note that only memory
card of 32 MB and less can be used by this printer.
·
This error code appears when a data name not existing on the memory
card is specified.
Check the data names on the memory card.
02: The memory card does not meet specifications. This memory card
cannot be used by this printer. Insert a memory card which can be used by
this printer. (See "Memory Card" of Chapter 2.)
03: The memory card is not a JEIDA card. Only JEIDA Ver. 4.2 memory
card can be used by this printer.
04: The card is an S-RAM or flash card which cannot be used by this printer.
05: There is no battery in the memory card. Replace the battery in the
memory card with a new one.
06: The memory card is write-protected. Cancel the write-protection of the
memory card.
07: The memory card requires formatting. Format the memory card from the
control panel.
09: The capacity of the memory card is insufficient. This error code appears
when an attempt is made to write more data on the memory card than
available memory. To halt the writing of data, first stop data transmissions
from the computer, and then the printer's CANCEL key. Press the FORM
FEED key if the message Waiting will appear in the message display.
The message display will return to reading Ready.
(Continued on next page)

Advertisement

Table of Contents
loading

Table of Contents