Volvo S60 Owner's Manual page 87

Volvo s60
Hide thumbs Also See for S60:
Table of Contents

Advertisement

Position
Specification
A
Dipped beam
/Dipped beam
off in good light conditions. The
"Tunnel detection*" function
activates dipped beam in poor
light conditions.
The function for "Main beam
with automatic activation*" can
be used.
Main beam flash operates in
this position.
Dipped beam
Main beam can be activated.
Main beam flash operates in
this position.
A
Applies to certain markets.
Volvo recommends that
mode is used,
as long as the traffic situation or weather con-
ditions are not unfavourable for the function for
"Main beam with automatic activation*".
Main beam flash
Move the stalk switch gently towards the steer-
ing wheel to the position for main beam flash.
2
Applies to certain markets, for headlamp control without AUTO mode.
Main beam comes on until the stalk switch is
released.
Dipped beam
When the engine is started, dipped beam is
2
activated automatically
if the headlamp con-
trol is in position
. If necessary, auto-
matic dipped beam for this position can be
deactivated by a workshop. Volvo recom-
mends that you contact an authorised Volvo
workshop.
In position
dipped beam is always
switched on when the engine is running or
when key position II is active.
Main beam
Main beam can be activated when the head-
lamp control is in position
Activate/deactivate main beam by moving the
stalk switch towards the steering wheel to the
end position and release. Alternatively, the
main beam can be deactivated by a light press
of the stalk switch toward the steering wheel.
When main beam has been activated the sym-
bol
illuminates in the combined instru-
ment panel.
03 Your driving environment
Main beam with automatic activation -
AHB*
Main beam with automatic activation (Active
High Beam - AHB) is a function which uses a
camera sensor at the top edge of the wind-
screen to detect the headlamp beams of
oncoming traffic or the rear lights of vehicles in
front, and then switches from main beam to
dipped beam. The lights are switched back to
main beam a second or so after the camera
sensor no longer detects any such light.
In cars with this function the headlamp control
has another design, see page 84.
This function can be activated when the head-
lamp control is in position
to take place, the engine must have been run-
ning for at least 20 seconds and the speed of
2
or
.
the car must be 20 km/h or higher.
*
Option/accessory, for more information, see Introduction.
Lighting
03
. For activation
``
85

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents