Kenmore 66513206K902 Installation Instructions Manual page 15

Connect to drain
1. To help minimize
vibration, route drain
hose to avoid contact
with motor, door springs,
water line, cabinet,
flooring or the edge of
the hole where it passes
through the cabinet.
2. Do not remove drain
loop from side of
dishwasher.
3.
4.
Place pan under end of drain hose. Pan will collect any
water in drain hose.
Place the smaller drain hose clamp onto the small end
of the drain hose.
/ hose clamp
5.
Push the drain hose into the connector up to the stop
on the drain hose.
connector stop
6. Use pliers to open clamp and slide clamp onto
connector between stops on connector as shown.
stops
Secure dishwasher in cabinet
opening
Tip Over Hazard
Do not use dishwasher until completely installed,
Do not push down on open door.
Doing so can result in serious injury or cuts.
1. If you have not already done so, open dishwasher door
and place towel over pump assembly and spray arm of
dishwasher. This will keep screws from falling into
pump area if you unintentionally drop them when
securing dishwasher to countertop.
2. Check that dishwasher is still level and centered side to
side in the opening.
3. Secure dishwasher to countertop or sides of cabinet
with two, #10 x 1/2"Phillips-head screws. The
dishwasher must be secured to keep it from tipping
when door is opened.
4.
5.
Open door about 3" (7.6 cm) and check that space
between inner door and tub is equal on both sides. If
spacing is not equal, loosen bracket screws and shift
tub. Tighten bracket screws.
Check that top of door does not contact screws,
brackets, or countertop. If it does, dishwasher must be
lowered and re-leveled.
6.
If securing to sides of cabinet, replace the plastic
buttons.
button
7. Remove towel from dishwasher.
8. Reinstall the lower dish rack.
Bottom sound pad installation (on some models)
1.
2.
3.
Remove the bottom sound pad from inside the
dishwasher and take it out of the plastic bag.
Place pad on the floor in front of the dishwasher,
making sure lettering is facing up and vinyl pad faces
down.
Fold up and hold the side panels down. Slowly slide the
pad toward the back of the dishwasher as far as it will
go, making sure not to push or pull any wires or hoses.
(Do not force.) Side panels will open to proper position.
NOTE: If there are pipes or other obstructions coming
up through the floor, you will need to cut a slit in the
pad to fit around the obstacle.
15