Advertisement
Available languages
Available languages
2. Remove 2 screws a ttaching a ccess p anel a ndlower
panel to dishwasher using a 1/4" hexsocket, n utdriver
or Phillips screwdriver.
3. Remove p anels andsetpanels aside onaclean surface.
4. Check t hatgrounding c lipis attached to thelower
panel.
lower
panel
clip
5.
6.
7.
water inlet valve
Apply Teflon ® tape or pipe
joint compound
to 90 ° elbow
fitting
and connect fitting to
water inlet valve.
Tighten elbow until snug, and
be sure that it faces to the
rear.
Remove terminal
box cover.
- If you are direct wiring:
install a UL Listed/CSA
Approved
clamp connector
to the terminal
box. If
using conduit,
use a UL Listed!CSA Approved
strain
relief
- If you are installing
a power supply cord kit, do so
now, following
kit instructions.
terminal
__
box cover
_
<_
cable clamp
4_
_
_
connector
dishwasher
wires
Helpful Tip:
Put cardboard
under dishwasher
until it is
installed
in cabinet opening. The cardboard
will help
cover floor covering
during
installation.
8.
Measure
height of cabinet opening
from underside
of countertop
to
floor where dishwasher
will be
installed
(you need the lowest
point). Check chart for that height
opening.
Put wheels in the required
position.
wheel
_
3
Number
of
Minimum
Wheel
turns on
cutout height
position
front leg
34" (86.4 cm)
1
10
341/4" (87 cm)
2
5
341/2" (87.6 cm)
3
0
9.
Turn both front leveler legs to the same
height.
If the minimum
cutout
height is less than
34" (86.4 cm), the rear wheels can be
removed
for additional
clearance.
This will
allow the dishwasher
to fit into a 337/8 `'
(86 cm) high cutout,
but the dishwasher
will be more difficult
to move into position.
front leg
If the wheels are removed,
cover the floor when
moving
the dishwasher.
If you have built-up
floors
1. Measure
height of opening
from underside
of
countertop
to built-up
floor. If the height is at
least 333/4" (85.7 cm), the
dishwasher
will fit into the
opening
without
modification
to the
countertop
or flooring.
j
countertop
333A,,
(85.7 cm)
min.
•
/ /b lilto?
2.
3.
Put wheels in Position
1 and turn the front leveler legs
up all the way.
Add shims as needed in the area shown to bring
dishwasher
up to proper height.
NOTE: Shims must be securely
attached to floor to
keep them from moving
when the dishwasher
is
operated.
2"
(5.1 cm)
6"
PA"
(15.2 cm)
23/4"
(7.0 cm)
(7.0 cm)
10
Advertisement
