Advertisement
5. Onmachines equipped w ithdrain pump, f orm
a U shape onthe endof thedrainhose, w ith
thehose pointed toward thedrain.
NOTE: If the drain hose isplaced in a standpipe
without forming a U shape, a siphoning action
could occur. There must be an air gap around
the drain hose. A snug hose fit can also cause a
siphoning action.
/
6. Carefully move the washer to its final location.
NOTE: Do not use the dispenser drawer or door to lift washer.
Excessivenoise and vibration can be prevented by properly
leveling the washer.
7. For free standing installation and with the washer in it's final
position, place a level on top of the washer. Adjust the leveling
legs so the washer is level front-to-rear and side-to-side, and
stable corner-to-corner.
COIN BOX ADJUSTMENT
The tight fit of the money box is set at the factory. Customer may
loosen fit as desired by loosening the slotted nuts. See FIG.2.
FIGURE2 (__0_-<
Slotled Nuts_
Keep A record of aft coin-box key numbers.
A lost key can only be replaced by ordering the key numbers from
the place were the unit was purchased. The key number is located
both on the key and behind the end panel of the coin box. If the
key number is not available, the lock must be drilled out to remove
the coin box.
Instructions
for Changing
Vend Price
TOOLS NEEDED
• Medium sized slotted screwdriver
• Small slotted Phillips screwdriver
Placeall screws and other items removed from coin slide assembly
on a cloth so they will not get lost.
STEP 1
Remove slide mechanism from meter case. (see FUGURE I).
r
FIGURE 1
Press down on alternate corners and sides and feel for the
slightest movement. Adjust the appropriate leg so the washer
is SOLID on the floor on ALL four legs. Keep the leveling leg
extension at a minimum for best performance of the washer.
8. For pedestal installations, See additional installation
instructions included with the pedestal.
g. Plug the power cord into a grounded outlet.
NOTE: Check to ensure the power is off at the circuit breaked
fuse box before plugging the power cord into an outlet.
10.Turn on the power atthe circuit breakedfuse box.
I 1.Be sure you have read the "important Safety Instructions"
before operating this washer.
12.Run the washer through a complete cycle. Check for water
leaks and proper operation.
13. Keep these instructions for future reference.
NOTE: A wiring diagram is located inside the washer on the
side panel.
STEP2
Remove the coin slide extension from coin slide by removing two
mounting screws and spacers
(see FIGURE2).
(2} Mounting
Screws
and Spacers
FIGURE2
Slide Return Spring
7
Advertisement
