Table of Contents
Advertisement
/
= Broil burner: Use 1/2" combination wrench to turn the
orifice hood down snug onto pin (approximately 2 to 2-1/2
turns). DO NOT OVERTIGHTEN. The burner flame cannot be
properly adjusted if this conversion is not made.
,, Reinstall the storage drawer. Complete installation
sections D through E, Pages 9-12. Checking for proper
cooktop burner and oven flame is very important.
YOU MUST ADJUST "LOW" SETTING FOR EACH COOKTOP
BURNER. SEE STEP 16, PAGE 10.
The small inner cone should have a very distinct blue flame
1/4" (6 mm) to 1/2" (13 mm) long. The outer cone is not as
distinct as the inner cone. L.R gas flames may have a
slightly yellow tip. If the flame [s noisy or blowing, [t is
getting too much air. If the flame is soft and lazy, it is not
getting enough air.
Natural gas conversion
[]Complete installation sections A-C (Pages 7-8) before
converting cooktop to natural gas. Check that main gas
supply line has been shut off and the power supply cord is
disconnected.
" Pressure regulator: Remove storage drawer and locate
pressure regulator at back of range. Remove plastic cover.
Turn cap marked "L.R" on front of pressure regulator
counterclockwise with a wrench to remove. Do Not disturb
or remove the spring beneath the cap. Turn the cap over
and reinstall cap on regulator so that the letter "N" is
visible. Replace plastic cover over cap.
plastic
regulator_
plastic
Natural
cap
--washer
--
Nat. gas
L.P, gas
DO NOT REMOVE THE PRESSUREREGULATOR.
t!_
@__/
reinstall
one
• •
of the
,
orifice
[] Surface Burners.
spud
U
screws
Remove burner caps. Use
\
_
snark electrode
_,.,,.
_
,
orifice
\
-
I_
a vmmps or uuaarex
spud
_
/
screwdriver to
remove
holder"--_,_
_,_
-/
the two screws holding the
_
)) _.__;_;
burner head down. Lift the
\\\"--_//_
burner head off the cooktop
_
to uncover the orifice spud
range cooktop
holder. The orifice spud is recessed in the holder.
Note: Reinstall one of the screws through the range cooktop
to hold orifice spud holder in place while removing and
replacing orifice spuds.
Locate the Natural gas orifice spuds in
literature package. Orifice spuds are
stamped with a number and marked with
two color dots.
5/!6"
nut driver
9
Natural
gas
orifice
spud
orifice spud
Replace orifice
_-L_
spud with the
_/_
number listed
,('(
_
in chart,
/ \-,_j_
orifice
/
number
burner
/
assembly
Page 14
Advertisement
Table of Contents
