Table of Contents
Advertisement
Check operation
Electronic ignition system
Cooktop and oven burners use electronic ignitors in place
of standing pilots. When a cooktop control knob isturned
to the "LIGHT" position, the system creates a spark to
light the burner. This sparking continues until the control
knob is turned to the desired setting.
When the oven control is set to the desired setting, a series
of sparks lights the oven burner. The sparking will stop
when burner gas lights. Sparking will again occur to re-light
the burner everytime the burner cycles back on again.
Check operation of cooktop
Check operation of oven burner
-, Open oven door.
Remove oven bottom:
Remove two screws at the rear of the oven bottom. Lift the
rear of the oven bottom up and back until the front of the
panel is away from the front frame. Remove from oven.
steel/glass
mirror
[] Push in and turn each surface unit control
knob to "LIGHT" position. The flame should light within
4 seconds. Turn control knob to "HIGH" position after
burner lights.
Check each cooktop burner for proper flame.
The small inner cone should have a very
distinct blue flame 1/4" (6 mm) to 1/2" (13 mm)
long. The outer cone is not as distinct as the
inner cone.
flame_
spreader
2 SCreWS
You can check the burner flame by removing the flame
spreader or by using a mirror.
Remove flame spreader:
Remove two screws from the front tabs of the flame
spreader. Lift front of the flame spreader and pull forward to
remove tabs from rear of oven.
Using a mirror:
insert mirror to one side of the burner. Look into mirror to
check flame.
[] Push in and turn each cooktop control knob
from "LIGHT" to "LOW" setting quickly. The low flame
should be a minimum, steady blue flame. If flame needs
to be adjusted, turn control knob to the "LOW" setting
and remove control knob. Insert a small fiat-blade
screwdriver into the valve stem. Turn the valve screw to
obtain the smallest flame that will not go out when the
control of a cold burner is quickly turned from "HIGH" to
"LOW". Repeat for other cooktop burners as needed.
[] Follow the instructionsfor your type of oven
controls.
Note: A faint ticking sound will be heard while the oven
burner lights.The oven burner should light within 8 seconds.
OFF
PUSHTO
TURN
I
WARM
/
OVEN ON O
,200
(TURN
OFF OVEN
WHEN
FLASHING)
CLEAN
OVEN HEATING
O
PUSH
TO
i
TURN
• 250
1
DOOR LOCKED/CLEANING
O
BROIL
e \
(CLOSE
DOOR
WHEN
FLASHING)
e
500
/
•
I
•
\
350
450
400
Push in and turn the oven selector control knob to
"350". if the burner fails to light due to air remaining in
the gas line, reset the oven control by turning selector
knob to "OFF" and then again to "350".
Page 10
Advertisement
Table of Contents
