Ddr3 Synchronous Dram Non-Ecc System Memory; Memory Configurations: Ultra Slim Desktop - HP Compaq 8000 Elite Series Quickspecs

QuickSpecs
Standard Features and Configurable Components (availability may vary by country)

DDR3 Synchronous DRAM NON-ECC System Memory

Memory upgrades are accomplished by adding single or multiple DIMMs of the same or varied sizes. This chart does not represent all
possible memory configurations. The HP Compaq 8000 Elite Series PC supports non-ECC DDR3 PC3-10600 (1333 MHz) and PC3-8500
(1066 MHz) memory.
CAUTION: You must shut down the computer and disconnect the power cord before adding or removing memory modules. Regardless
of the power-on state, voltage is always supplied to the memory modules as long as the computer is plugged in to an active AC outlet.
Adding or removing memory modules while voltage is present may cause irreparable damage to the memory modules or system
board.

Memory Configurations: Ultra Slim Desktop

Maximum Memory*
Total Memory
1 GB
2 GB
(dual channel symmetric)
4 GB
(dual channel symmetric)
8 GB
(dual channel symmetric)
* The Intel Q45 Express chipset includes a built-in Management Engine (ME), which allocates memory for manageability functions.
Management Engine memory is shared with system memory. If the PC contains a single SO-DIMM, 16 MB of memory is pre-allocated
for it at system startup. If the PC contains two SO-DIMMs, 32 MB of memory is pre-allocated. This memory is not made available to the
operating system, just as pre-allocated video memory is not available.
Supports up to 8 GB of DDR3 SDRAM using SO-DIMM modules. Slot 1 is black and must always be
populated. Not all memory configurations possible are represented below.
NOTE:
For systems configured with more than 3 GB of memory and a 32-bit operating system, all memory may
not be available due to system resource requirements.
DA - 13424 North America — Version 28 — October 19, 2011
Channel A (black)
1 GB
1 GB
2 GB
4 GB
HP Compaq 8000 Elite Series
Slot
Channel B (white)
1 GB
2 GB
4 GB
Page 10