Style 2: Direct wire strain relief
•
Use Phillips screwdriver to remove screws from panel on
back of range.
•
Replace cord/conduit
plate and insert screws.
•
Lift range back panel up and off.
Assemble a UL listed conduit connector in the opening.
Use Phillips screwdriver to remove screws and slide
cord/conduit
plate down and out.
Position cord/conduit
plate as shown in the following
illustration.
A. Removable retaining nut
B. Strain relief
Feed the flexible conduit through the strain relief, allowing
enough slack to easily attach wiring to the terminal block.
Tighten strain relief screw against the flexible conduit.
5=
6.
Replace back panel and screws on rear of range.
Complete installation following instructions for your type of
electrical connection:
4-wire (recommended)
3-wire (if 4-wire is not available)