Advertisement
Tools needed for
installation:
level
)liers
Ci i
utility
knife
fiat-blade
screwdriver
Parts supplied for
installation:
Remove
parts from packages.
Check
that all parts were included,
I hose clamp
2 inlet hoses
4 flat water hose washers
2 front-leveling
legs with nuts
I drain hose
PAGE 3
Electrical
requirements
Electrical Shock Hazard
Plug into a grounded 3-prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions
can result in death, fire, or electrical
shock.
If codes permit and a separate ground
wire is used, it is recommended
that a
qualified electrician
determine
that
the ground path is adequate.
Do Not ground to a gas pipe.
Check with a qualified electrician
if
you are not sure the washer is properly
grounded.
Do Not have a fuse in the neutral or
ground circuit.
A 120-volt, 60-Hz, AC-only,
15- or
20-ampere
fused electrical
supply is
required,
(Time-delay
fuse or circuit
breaker
is recommended.)
It is
recommended
that a separate
circuit
serving only this appliance
be provided,
Recommended
ground method
For your personal safety, this appliance
must be grounded.
This appliance
is
equipped
with a power supply cord
having 3-prong ground plug. To
minimize possible shock hazard, the
cord must be plugged
into a mating
3-prong ground-type
outlet, grounded
in accordance
with local codes and
ordinances.
See Figure 1. If a mating
outlet is not available,
it is the personal
responsibility and obligation
of the
customer to have a properly grounded
3-prong outlet installed by a qualified
electrician.
WARNING - Improper
connection
of
the equipment-grounding
conductor
can result in a risk of electric
shock.
Check with a qualified
electrician
or
serviceman
if you are in doubt
as to
whether
the appliance
is properly
grounded,
Do not modify
the plug
provided
with the appliance
- if it will
not fit the outlet, have a proper
outlet
installed
by a qualified
electrician.
3-prong
ground-
3-prong
type
outlet
------_--J]lllllt_l
ground
plug
power supply
cord
Figure ]
Now start...
With washer
in laundry
area.
Excessive Weight Hazard
Use two or more people to move
and install washer.
Failure to do so can result in back
or other injury.
shipping
Remove
tape
that covers
[] shipping
strap, Pull to
completely
remove
the shipping
strap with 2 cotterpins
from the inside
of the washer,
Pull firmly to remove the
end of shipping
strap from
the back of the washer, The shipping
strap plug must be completely
removed
from the washer for the
self-leveling
legs to be released,
Save the shipping
strap for use in
Step 6.
Advertisement
