Advertisement
Quick Links
Installation Instructions
IMPORTANT:
Read and save these
instructions.
IMPORTANT:
Installer: Leave Installation Instructions with the homeowner.
Homeowner: Keep Installation Instructions for future reference.
Save Installation Instructions for local electrical inspector's use.
120-volt
60-Hz
Washer
Part No. 3952817 Rev. B
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on
your appliance. Always read and obey all safety messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you
and others.
All safety messages will follow the safety alert symbol and either the word
"DANGER" or "WARNING". These words mean:
DANGER
WARNING
All safety messages will tell you what the potential hazard is, tell you how to
reduce the chance of injury, and tell you what can happen if the instructions
are not followed.
Parts supplied:
Open lid and remove parts from
inside washer. Check that all parts
were included.
2 inlet hoses
1 drain
hose
Tools needed:
pliers
scissors
You can be killed or seriously injured if
you don't immediately follow instructions.
You can be killed or seriously injured if
you don't follow instructions.
4 flat water
hose washers
yellow clamp
drain hose clamp
2 front leveling legs
literature package
(inside washer)
with nuts
utility
level
knife
adjustable wrench or
9/16" open-end
wrench
Advertisement
Related Manuals for Whirlpool Michigan 49022
Summary of Contents for Whirlpool Michigan 49022
-
Page 1: Installation Instructions
Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on Installation Instructions your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. -
Page 2: Location Of Washer
Before you start... Location of washer: Check location where washer will be installed. Make sure you have everything necessary for correct installation. Proper installation is your responsibility. Recessed area instructions Hot and cold water faucets: Should be within This washer may be installed in a recessed area or closet. 3-1/2 feet of upper The installation dimensions openings in top and bottom of... -
Page 3: Inlet Hose Connection
Now start... With washer in laundry area. Level washer. Cold water inlet valve Attach inlet hoses to hot and cold water valves. Plug power supply cord into grounded outlet. Hot water inlet valve Insert Attach washers inlet hoses Read and into inlet to water then... - Page 4 Drain hose • Wet the inside end of the drain IMPORTANT: THIS PROCEDURE hose with tap water. DO NOT USE connection: MUST BE FOLLOWED TO ANY OTHER LUBRICANT. ASSURE PROPER Run water • Squeeze ears of drain hose clamp INSTALLATION. through with pliers to open and place both faucets into...
-
Page 5: Completing Installation
Both numbers are on the model/serial rating plate located under the washer lid and on the top of the washer. Part No. 3952817 Rev. B Benton Harbor, Michigan 49022 © 2001 Whirlpool Corporation Printed in U.S.A.