Table of Contents
Advertisement
Install the water inlet hose
Confirm the water faucet
Water faucet,suitable
Outlet end surface
It is required that the front end shall be longer than 10cm.
The outlet end surface of the faucet shall be flat and smooth. If not please file it
to avoid leakage.
Connection between the water inlet hose jointer and
the water faucet
1.Press the lower end of the lock lever and push down the slider. Take off the water inlet
hose jointer from the water inlet hose component. See to Figure 1.
2.Loosen the screw till the water faucet can be accessed. Put the jointer of the water
inlet hose on the faucet. See to Figure 2. (If the faucet is too large and the jointer can
not be set on the water faucet, please loosen the four screws and take out the
bushing in the jointer. See to the figure.)
Locking lever
Water inlet pipe
3.Fasten the four screws evenly. See to Figure 4.
4.Take off the nameplate. Twist the fastening nut as per the indication of the figure to
seal up the outlet end surface of the faucet. See to Figure 5.
Remarks: Before installation, the threading is 4mm above the upper surface of
the nut. After installation, the threading is 2mm above the upper surface of the
nut. See to Figure 6.
Figure 4
>10mm
Water inlet pipe jointer
Slider
Screwdriver
Figure 1
Nut
Figure 5
Before Using
Before Using
Water faucet,not suitable
Screw
Mark label
Figure 2
Figure 3
About 4mm before twisting
About below 2mm after twisting
Figure 6
Liner
Advertisement
Table of Contents
