Principal Parts - Singer 6233 Instruction Manual

Principal Parts
1. Hand Wheel provides a means for
14. Presser Foot Lifter, at the back of
raising or lowering the needle.
machine, lets you raise and lower
2. Bobbin Winder lets you fill the bobbin presser foot,
with thread quickly and easily.
IS. Thread Cutler, on presser foot
3. Pattem Display Panel shows a vari-
sleeve, is built-in for ease,
ety of pattems available for your sew- 16. Slide Plate opens for easy removal
ing needs.
and replacement of bobbin.
4. Friction-Free Spool Pin and Cap
17. Feed system moves fabric under
hold the top thread supply and allow it presser foot.
to unwind smoothly as the spool does
.
Pnsr Foot holds fabric against the
not turn,
feed system and snaps on and off
5. Stitch Width Lever controls the width
of pattems and sets the needle for
19m Bed is the work surace of the
straight stitching.
machine.
6. Snap-InThreadGuidehelpstoinsure
20. Sthch Length Lever allows for a
a smooth flow of thread from the varetyofstitchlengths.
spool to the tension.
21. Power and Light Switch turns on the
7. Bobbin Winder Tension Disc pro- machine and sewing light at the same
vides thread tension for bobbin time.
winding.
22. Reverse
Lever provides either
8. Auto Needle Thread Tension Lever momentary or continuous reverse
controls top thread tension. abric movement.
9. Face Plate is a removable cover pro- 23. Pattem Selector Dial turns directly to
tectng movable pare s and sewing any of the 10 patterns, plus buttonhole,
lighm.
shown on the pattern display panel.
10. Sewing Light illuminates sewing 24. StItch Balance Ring adjusts appear-
area.
~ ~ ~
swig
ante of Special Stitch patterns and
buttonholes.
11. One-Way Needle
Clamp holds 25. Electrical Power Cord connects
needle in machine and prevents incor- your Ctri outet.
rect insertion.
machine to your electical outlet.
12. Needle Plate supports the fabric
26. Speed Controller, designed for safety
during sewing. and convenience, regulates the elec-
tronic solid state speed control.
13. Removable Extension Table lets you
change the machine bed from flat to
free arm.
3