Advertisement
Installation
with
cabinets
and wall
range is 5"
WALL
Fig, D
Anti-tip
installation
IMPORTANT
SAFETY
WARNING!
To reduce the risk of tipping
of the range, the range
must be secured to the floor by properly
installed
anti-
tip bracket and screws packed with the range. Failure
to install the anti-tip bracket will allow the range to tip
over if excessive
weight is placed on an open door or if
a child climbs upon it. Serious
injury
might result from
spilled
hot liquids
or from the range itself.
if range is ever moved to a different
location,
the anti=
tip brackets
must also be moved and installed with the
range.
Instructions
are provided
for installation
in wood or
cement fastened
to either the floor or wall. When
installed
to the wall, make sure that screws completely
penetrate
dry wall and are secured
in wood or metal.
When fastening
to the floor or wall, be sure that screws
do not penetrate electrical
wiring or plumbing.
Anti=tip
bracket
installation
instructions
2_
3_
Locate the Bracket Using the Template
- (Bracket
may be positioned on either the left or right side of the
range. Refer to Figs. 24 thru 26 to position the bracket
if template is not available). Mark the floor or wall
where left or right side of the range will be located. If
rear of range is against wall or no further than 1-1/4"
from wall when installed, you may use the wall or floor
mount method. If molding is installed and does not
allow the bracket to fit flush against wall, remove
molding or mount bracket to floor. For wall mount (Fig.
24), locate the bracket by placing the back edge of the
template against rear wall and the side edge of
template on the mark made referencing the side of the
range. Place bracket on top of template and mark
location of the screw holes in wall. If rear of range is
further than 1-1/4" from wall when installed, attach
bracket to the floor. For floor mount (Figs. 24 or 25),
locate the bracket by placing back edge of the
template where the rear of the range will be located.
Mark the location of the screw holes shown in
template.
Drill Pilot Holes & Fasten Bracket
- Drill 1/8" pilot
hole where screws are to be located (Fig. 23). If
bracket is to be mounted to the wall, drill pilot hole at
an approximate
20 ° downward angle. If bracket is to
be mounted to masonry or ceramic floors, drill 3/16"
pilot hole 1-3/4" deep. The screws provided may be
used in wood or concrete material.
Use 5/16" nut-
driver or flat head screwdriver to secure the bracket in
place.
Level & Position
Range - Level range by adjusting the
(4) leveling legs with a wrench. Note: A min. clearance
of 1/8" is required between bottom of range and
leveling legs to allow room for bracket. Slide range
back into position (Fig. 26). Remove lower panel or
storage drawer to visually check that rear leveling leg
is inserted into and fully secured by the bracket. For
models with a warmer drawer or broiler compartment,
grasp the top rear edge of the range and carefully
attempt to tilt it forward. Use a level to check your
adjustments (Fig. 27).
Fig. 23
Advertisement
