Advertisement
To eliminate the risk of burns
or fire by reaching over
heated surface units, cabinet
storage space located above
the surface units should be
avoided, if cabinet storage is
to be provided, the risk can
be reduced by installing a
range hood that projects
horizontally
a minimum
of 5"
beyond the bottom of the
cabinets.
Cabinet
and countertop
dimensions
•
Check for wall and cabinet clearances where the range will be installed.
•
Check the stability of the floor where the range will be installed.
•
Check for proper electrical and gas supply.
Note: All dimensions
provided are minimal unless otherwise stated.
18"
13"
Minimum
J
Fig. A
2=1/4"
Back
Wall
Fig. B
Install a flush mount
240V 40/50 ampere
electrical wall outlet
in the shaded area.
.
Do not seal the range to side cabinets.
.
Do not pinch the power supply cord between the
range and the wall,
.
If cabinet depth is greater than 25", the oven front
frame must extend beyond cabinet front by 1/2"
minimum.
All openings
in the wall or floor where the range is
to be installed
must be sealed.
t1"
-----_1 "I---_
6"
BackWal
"
"'_"
-,........
4"**
L_
ThiSarea
shadedis
for thrufl°°rthe _
..............
floor connection of
I
M_x.
Add 1/2 NPT 90
....
black pipe elbow to I
gas pipes[uD an(]
.
M
the gas supply pipe
shut-off valve.
I
stub and orient the
Fig.
C
elbow as shown,
j
Note: The gas supply pipe stube and elbow
assembly centerline
should not exceed 4"
height form the floor.
Advertisement
