Quickstart - Samson AirLine Synth AR300 Owner's Manual

QuickStart

If you've had some prior experience using wireless systems, these QuickStart
instructions will get you up and running with your AirLine UHF microphone system in
a matter of minutes! Detailed instructions for setting up and using your AirLine Synth
system can be found on page 15 of this manual, and the "Guided Tour" sections on
pages 10- 14 provide full descriptions of all AirLine component controls and displays.
1. Unpack the AR300 receiver and AX300
transmitter and plug the AX300 into
the include Samson Q7 or any dynamic
microphone.
2. Physically place the AR300 receiver near
your mixer. Extend its antennas vertically
and spread the tips horizontally outwards.
3. Set the power switch on your AX300
transmitter to the "off" position (away from
the arrow) and place a fresh AA battery
in it. Then turn the transmitter back on
momentarily; its LED will flash once and
then go off if the battery is sufficiently
strong. Once battery strength is verified,
turn the transmitter off again, then put it
aside for now.
4. Connect the included AC power supply to the rear of the AR300 and then to an
available wall socket. Turn the AR300 on momentarily to confirm that the unit has
power. Then turn the AR300 power off.
5. Turn your mixer off, or mute the channel and make the physical cable connection
between an audio input and the AR300 output jack.
6. Turn the Level knob on the AR300 completely counterclockwise, then turn its
power on.
8