1. Manuals
  2. Brands
  3. Samson Manuals
  4. Transmitter
  5. AirLine SYNTH
  6. Owner's manual

Samson AirLine SYNTH Owner's Manual

Wireless beltpack system
Hide thumbs
Table of Contents

Advertisement

Quick Links

WIRELESS BELTPACK SYSTEM
WIRELESS BELTPACK SYSTEM
WIRELESS BELTPACK SYSTEM
WIRELESS BELTPACK SYSTEM

Advertisement

Table of Contents
loading

Related Manuals for Samson AirLine SYNTH

Summary of Contents for Samson AirLine SYNTH

  • Page 1 WIRELESS BELTPACK SYSTEM WIRELESS BELTPACK SYSTEM WIRELESS BELTPACK SYSTEM WIRELESS BELTPACK SYSTEM...

  • Page 2: Important Safety Instructions

    WARNING TO PREVENT FIRE OR SHOCK HAZARD. DO NOT USE THIS PLUG WITH AN EXTENON CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PRESENT BLADE EXPOSURE. TO PREVENT FIRE OR SHOCK HAZARD. DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. TO PRVENT ELECTRICAL SHOCK, MATCH WIDE BLADE PLUG TO WIDE SLOT FULLY INSERT.
  • Page 3 ATTENTION: Pour éviter tout risque d’électrocution ou d’incendie, ne pas exposer cet appareil à la pluie ou à l’humidité. Pour éviter tout risque d’électrocution, ne pas ôter le couvercle ou le dos du boîtier. Cet appareil ne con- tient aucune pièce remplaçable par l'utilisateur. Con ez toutes les réparations à un personnel quali é. Le signe avec un éclair dans un triangle prévient l’utilisateur de la présence d’une tension dangereuse et non isolée dans l’appareil.
  • Page 4 PRECAUCION: Para reducir el riesgo de incendios o descargas, no permita que este aparato quede expuesto a la lluvia o la humedad. Para reducir el riesgo de descarga eléctrica, nunca quite la tapa ni el chasis. Dentro del aparato no hay piezas susceptibles de ser reparadas por el usuario.
  • Page 5 Copyright 2011, Samson Technologies Corp. v2.1 Samson Technologies Corp. 45 Gilpin Avenue Hauppauge, New York 11788-8816 Phone: 1-800-3-SAMSON (1-800-372-6766) Fax: 631-784-2201 www.samsontech.com...

  • Page 6: Table Of Contents

    Guided Tour - AL300 Transmitter....7 Setting Up Your AirLine Synth system ... .9 AR300/AL300 Operation ....12...

  • Page 7: Introduction

    SPECIAL NOTE for U.S. purchasers: Should your AirLine Synth system ever require servicing, a Return Authorization number (RA) is necessary. Without this number, the unit will not be accepted. If your AirLine Synth system was purchased in the United States, please call Samson at 1-800-372-6766 for a Return Authorization number prior to shipping your system.

  • Page 8: Quickstart

    AirLine UHF wireless system in a matter of minutes! Detailed instructions for setting up and using your AirLine Synth system can be found on page 15 of this manual, and the “Guided Tour” sections on pages 10 - 14 provide full descriptions of all AirLine component controls and displays.
  • Page 9 QuickStart 7. Now to set the channel, press and hold the EDIT control until the display shows the group number with three asterisks. Next, the AR300 will display the selected Channel number and then the IR SET will begin. 8. Once you see the IR SET flashing in the LCD, hold the AL300 transmitter, with the IR window facing the front of the AR300, approximately 6 inches away from the...

  • Page 10: Guided Tour - Ar300 Receiver / Front Panel

    Antenna B (the antenna on the right) should be placed in a vertical position. Both antennas can be folded inward for convenience when transporting the AR300. See the “Setting Up and Using the AirLine Synth System” section on page 15 in this manual for information about antenna installation and positioning.
  • Page 11 Guided Tour - AR300 Receiver / Front Panel EDIT Control – This rotary encoder control knob/switch is used to control and set several menu functions and parameters displayed in the LCD display and it is also used to preform the automatic Channel Scan. Power Switch - Use this to turn the AR300 power on and off.

  • Page 12: Guided Tour - Ar300 Receiver / Rear Panel

    E: Audio Output Level switch - Sets the audio output level attenuation of the XLR output to -20 dBm (line level) or -40 dBm (mic level). See “Setting Up and Using the AirLine Synth System” on page 15. * If required, both outputs can be used simultaneously.

  • Page 13: Guided Tour - Al300 Transmitter

    AL300 by 15 dB when your microphone is putting out too hot a signal. See the “Setting Up and Using the AirLine Synth system” section on page 12 in this manual. 3: Power / Battery LED - This red...
  • Page 14 See the “Setting Up and Using the AirLine Synth system” section on page 2 in this manual for more information about antenna positioning. 7: IR Lens - This acrylic window is used...

  • Page 15: Setting Up Your Airline Synth System

    Setting Up Your AirLine Synth system The basic procedure for setting up and using your AirLine Synth system takes only a few minutes: 1. Remove all packing materials (save them in case of need for future service) and check to make sure that the supplied power adapter is the correct voltage for your country.
  • Page 16 11. Now it’s time to set the audio levels. Turn on your mixer and/or amplifier but keep its volume all the way down. Plug in the included Samson SE10 or LM10 microphone into the AL300. Begin speaking at a normal performance level while observing the AR300 AF Meter.
  • Page 17 “Min” position (so as to have the greatest overall range available). 13. When first setting up your AirLine Synth system in a new environment, it’s always a good idea to do a walkaround in order to make sure that coverage is provided for your entire performance area.

  • Page 18: Ar300/Al300 Operation

    AR300/AL300 Operation Setting a Group and Channel Manually The AR300 receiver contains 320 selectable channels for N and U band, and 71 selectable channels for E band. All channels are organized into a series of groups. Each group contains channels that are compatible for simultaneous use. When using multiple systems, each system should be assigned to the same group in order to maximize the number of compatible channels.
  • Page 19 AR300/AL300 Operation Operating In FREE Mode You can tune in an exact frequency using the AR300’s FREE mode. Once you are in FREE mode you can change the frequency by 25 kHz steps. For most situations, it’s better to use the GROUP Channel plan but if your application requires an exact frequency, follow these steps to operate in FREE mode.

  • Page 20: Specifications

    Specifications SYSTEM SPECIFICATIONS Channels 320 channels 25kHz Step (N and U Bands) 71 channels 25kHz Step (E Band) Operating Frequency 639.025–647 MHz 798.025–806 MHz (not for use in the USA) 863–865 MHz (not for use in the USA) Frequency Type Modulation Type Noise Reduction Type Compander...
  • Page 21 Specifications TRANSMITTER (AL300) Oscillation Type Crystal-controlled PLL frequency systhesized Modulation Type Antenna 1/4 Wave Length Wire Type Input Impedance 290k ohms(ATT:0dB), 330k ohms(ATT:-15dB) Maximum Input Level -2dBv(ATT:0dB), +15dBv(ATT:-15dB) Switches/Controls POWER switch, MUTE switch, ATT switch, GAIN control Display CHANNEL (LCD), BATT (LED) Interface Infrared Phantom...
  • Page 22 FCC Rules and Regulations Samson wireless systems are type accepted under FCC rules parts 90, 74 and 15. Licensing of Samson equipment is the user’s responsibil- ity and licensability depends on the user’s classification, application and frequency selected. This device complies with RSS-210 of Industry &...
  • Page 23 11788 USA declare under our own responsibility that the Products: Equipment: Wireless Microphone System Model #: Samson AirLine Synth - AR300 Receiver & AL300 / AX300 / AG300 Transmitters are in conformity with the essential requirements of the following EC Directive(s) when...
  • Page 24 Samson Technologies Corp. 45 Gilpin Avenue Hauppauge, New York 11788-8816 Phone: 1-800-3-SAMSON (1-800-372-6766) Fax: 631-784-2201 www.samsontech.com...

This manual is also suitable for:

Airline synth al300Airline synth ar300

Table of Contents