Diamond Multimedia Viper V700 SERIES User Manual page 16

11. After the installation is complete, click Next to restart your computer.
Congratulations, you have successfully installed your new Diamond graphics
accelerator!
Manual Installation of Diamond Drivers
If, for some reason, you need to install the drivers for your Diamond product
"manually," follow the procedures below for your operating system. If you need to
update your drivers, please see the chapter on Diamond Software Tools later in this
user guide.
Windows 98/95 Manual Driver Installation
To install the driver for your Diamond graphics accelerator, go to Start > Settings >
Control Panel > Display. The Display Properties page appears. Continue with the
following procedure:
1. Click the Settings tab, then click the Advanced button.
2. Click the Adapter tab, and then click the Change button. The Update Device
Wizard appears.
3. Click Next and choose Display a list of all the drivers ...
4. Click Next and then click Have Disk...
5. Insert the installation CD. If your system is set to "auto-play," the Diamond
installation program opens. Click Quit to exit the program.
6. From the Install From Disk dialog, type X:\Win9x\English\Drivers (where "X" is
the letter of your CD- or DVD-ROM drive). Click OK. The .inf file for your
Diamond product should appear in the Select Device window.
7. Choose the driver that applies to your operating system and click OK.
8. Click OK again, and then click Next. The driver file(s) should be copied to your
system.
Note—If you are prompted to keep or replace existing files, keep the newer files.
9. Click Finish, then click Close.
10. Click Close to exit the Display Properties dialog.
11. Reboot your computer.
Windows NT 4.0 Manual Driver Installation
To install the NT 4.0 driver for your Diamond graphics accelerator, go to Start >
Settings > Control Panel > Display. The Display Properties page appears. Continue
with the following procedure:
1. Click the Settings tab, then click the Display Type... button.
12