Diamond Multimedia Viper V700 SERIES User Manual page 11

5. Click Next and select Show All Hardware. Click on Standard Display Adapter
Types and select Standard Display Adapter (VGA).
6. Click Next.
7. If a warning dialog appears, asking whether you want to use this driver, click
Yes. Then click Next.
8. Windows asks you if you want to restart your computer. Click No.
9. Shut down your computer. You are now ready to remove your old graphics card
and install your new Viper V700 Series board.
Setting the Standard VGA Under Windows NT 4.0
To set your display to Standard VGA under Windows NT 4.0:
1. From the Start menu, go to Start > Settings > Control Panel, then double click
on Display. The Display Properties sheet appears.
2. Click on the Settings tab, then click the Display Type button.
3. Under Adapter Type, click on the Change button. The Change Display window
appears.
4. Under Manufacturers, select Standard Display Types. Under Display, choose
VGA Compatible Display Adapter.
5. Click on OK. You may need to insert your Windows NT 4.0 CD-ROM.
6. Click on Close and OK to accept the changes.
7. Shut down your computer. You are now ready to remove your old graphics card
and install your new Viper V700 Series board.
Note—You should have the latest Service Pack for NT 4.0 (Service Pack 4) loaded for
the Viper V700 Series to operate properly. Service Pack 4 is available from
Microsoft's web page, www.microsoft.com.
After you have completed the steps above and removed your old graphics card, you
can continue with the procedures below to install your Viper V700 Series board.
Installing Your Viper V700 Series AGP Board
Installing your card should take just a few minutes. Please note that the illustrations
provided in this section are for instructional use only; the card shown may look
different than the one you purchased. To install your AGP card, follow these steps:
7