Advertisement
Quick Links
Advertisement
Related Manuals for Krix Tektonix
Summary of Contents for Krix Tektonix
- Page 1 Owner’s Manual Tektonix and Volcanix...
- Page 2 Congratulations on choosing Krix setup in brief The following setup procedure will help you achieve the best performance from your subwoofer: 1. controls and features Familiarise yourself with the controls and features of your subwoofer. 2. positioning Determine a suitable location for your subwoofer unit.
-
Page 3: Controls And Features
controls and features Volume menu items -30dB current menu settings current menu settings up/down power LED menu back/forward blue - on red - standby Use the back/forward arrows to access the following menus Volume Power Mode Adjusts the subwoofer’s output level. Can be set to auto sense or 12V trigger. - Page 4 controls and features 12V trigger When a 12V signal is a applied to the trigger input the subwoofer will switch on from standby and the red active LED will illuminate. Use a 3.5mm mono lead to make the connection to an AV amp/receiver equipped with a trigger output.
- Page 5 Unlike conventional subwoofers with hard to utilises Microchip® laser trimmed digital venting, with the vent exhibiting the same flare reach rear controls, the Tektonix and Volcanix potentiometers, this offers precision adjustment radius internally and externally. This lowers feature a front panel with precision digital...
- Page 6 Please refer to the link on the subwoofer page of the Krix website for Play some music or a movie with heavy Often the best place for a subwoofer is in a suggestions.
- Page 7 connection & calibration - AV receiver connection and defaults It is recommended that you use Line Level RCA connections for home theatre applications. • Ensure the mains power switch is off and connect the mains power cord. • Connect the subwoofer pre-out (SW) to AV receiver on your receiver/processor to the line in L/LFE input on your subwoofer (see...
- Page 8 & calibration - stereo system connection and defaults Connection Method 1: Line Level calibration Connect the Tektonix or Volcanix subwoofer Requires your amplifier to feature L&R pre- • Switch on mains power switch (on the to a stereo amplifier either via the high out connections.
- Page 9 R sub out to right subwoofer L/LFE input Main AV Receiver Main AV Receiver Main AV Receiver From L & R sub-outs From sub-out(mono) From L & R sub-outs Tektonix or Volcanix subwoofer one subwoofer two left subwoofer right subwoofer...
-
Page 10: Troubleshooting
Amplifier over-temperature condition. May be Subwoofer will resume normal operation when the result of continual use of the subwoofer at unit cools. If problem persists contact your Krix high volume levels. retailer or Krix directly. Power LED - flashing blue Amplifier overcurrent condition. -
Page 11: Specification
Distortion - Input to Speaker Left Input (mono) 300mV RMS for maximum output queries Line Level Inputs If you have any queries regarding the Tektonix Left + Right Input (stereo) 150mV RMS for maximum output or Volcanix setup procedure or any other Krix General... - Page 12 Krix Loudspeakers Pty Ltd 14 Chapman Road Hackham SA 5163 Australia T 61 8 8384 3433 F 61 8 8384 3419 listen@krix.com Rev #10001 krix.com Please read these important safety instructions before you plug in this equipment. Please retain these instructions for future reference.