Page 2
The Seismix 3 and Seismix 5 active subwoofers will complement existing Stereo or Home Theatre systems producing an increase in low frequency performance for a deep experience. The Seismix 3 and Seismix 5 are compatible with a variety of small to large sized, sealed or vented, main/satellite speakers.
Page 3
LED will flash. Warning: it is recommended that the unit is turned off at the mains power if being left unattended for any extended periods. Standby Mode Krix have included an energy saving device when the unit is in Standby mode, meaning the Seismix draws a meagre 3 watts (costing approximately AUD$5.00 for 1 year to run). Symetrix Vent...
Page 4
Two pairs of terminals are provided so that the speaker level signals can “pass through” the subwoofer on the way to the main speakers (see figure 1 or 3).
If you have any queries regarding the Seismix, the set up procedure or any other KRIX product, please contact your nearest Krix retailer or Krix direct. Contact details are on the back cover of this booklet.
Page 6
Seismix 3: specifications Drivers Bass Driver Nominal 255mm (10”) diameter paper cone driver developed for high level, low frequency reinforcement Electronics Amplifier Power 200 watts RMS into the nominal 4 ohm driver Maximum instantaneous power 400 watts Amplifier S/N >70dB Distortion - Input to Speaker <0.1% - @ 80 watts RMS...
Page 7
Seismix 5: specifications Drivers Bass Driver Nominal 305mm (12”) diameter paper cone driver developed for high level, low frequency reinforcement and large linear cone travel Electronics Amplifier Power 400 watts RMS into the nominal 4 ohm driver Maximum instantaneous power 800 watts Amplifier S/N >70dB Distortion - Input to Speaker...
Page 8
Krix Loudspeakers Pty Ltd 14 Chapman Road Hackham SA 5163 Australia T 61 8 8384 3433 F 61 8 8384 3419 listen@krix.com krix.com...