Sapido RB-1632 User Manual page 82

A: Periodically, a new Flash Code is available for RB-1632 on your product supplier's
website. Ideally, you should update RB-1632's Flash Code using Firmware
Upgrade on the System Management menu of RB-1632 Settings.
5. Q: My 11n Mobile Server Router cannot connect to the ISP?
A: There are three possible solutions.
1. Check the Cable/XDSL modem is power on.
2. Check the Cable/XDSL link light is on to verify a good physical connection.
3. Check the WAN port LED to verify if the Cable/XDSL modem is connected to the
router:
If your ISP Login method is following, please make sure the username and password
are correct or not.
If your ISP is using dynamic IP addressing (DHCP) then the DHCP protocol does not
have the authentication feature. Some Cable service providers often use the following
to determine user's identification.
6. Q: Why is that I can ping to outside hosts, but cannot access Internet websites?
A: Check the DNS server settings on your PC. You should get the DNS servers settings
from your ISP. If your PC is running a DHCP client, remove any DNS IP address
setting. As the router assign the DNS settings to the DHCP-client-enabled PC.
7. Q: RB-1632 couldn't save the setting after click on Apply button?
A: RB-1632 will start to run after the setting finished applying, but the setting isn't written
into memory. Here we suggest if you want to make sure the setting would be
written into memory, please reboot the device via Reboot under System
Management directory.
http://www.sapido.com.tw/ 82 User Manual 1.0