Windows Xp Ip Setup - D-Link NetDefend SOHO DFL-160 User Manual

Appendix B. Windows XP IP Setup
A Microsoft Windows PC can be used as the management workstation for initial setup of a
DFL-160. Usually explicit configuration of the IP address of the PC's chosen Ethernet interface
should not be needed since the DFL-160 automatically assigns the workstation's address using
DHCP.
If DHCP cannot be used, the workstation IP address should be configured manually and this section
describes the steps to do that.
Traffic must be able to flow between the designated PC Ethernet interface and the DFL-160 LAN
interface so they must be on the same IP network. This means the PC's interface should be assigned
the following static IP addresses:
• IP address: 192.168.10.30
• Subnet mask: 255.255.255.0
• Default gateway: 192.168.10.1
To configure these settings on a Windows XP system, perform the following steps:
1. Click the Windows Start button.
2. Right click on My Network Places and select Properties.
3. Right click the chosen Ethernet interface and select Properties.
4. Select Internet Protocol (TCP/IP) and click Properties.
5. Enter the IP addresses given above and click OK.
121