Table of Contents
Advertisement
Installation
Instructions
5. Place the blower unit back into the opening.
CAUTION:
Do not pull or stretch the blower unit
wiring. Make sure the wires are not pinched.
6, Secure blower unit to microwave with the screw.
B4. INSTALLATION
PROCEDURE
FOR
EXHAUST
ADAPTOR
AND
PROPER
DAMPER
OPERATION
CHECK
1, Remove and save screw
from the panel-outer
\
Exhaust Adaptor
and Damper is shipped
after being assembled to the fitter-upper.
2, Slide exhaust adaptor following the instructions
show in diagram.
3, Make sure tape securing damper is removed and
damper pivots easily before mounting microwave
4, Lift damper and Re-screw at same location as (1)
•
You will need to make adjustments
to assure
proper alignment with your house exhaust duct
after the microwave
is installed.
B5.__. MOUNT THE MICROWAVE
OVEN
FOR EASIER INSTALLATION
AND PERSONAL
SAFETY, WE RECOMMEND
THAT TWO PEOPLE
INSTALL THIS MICROWAVE
OVEN.
IMPORTANT:
Do not grip or use handle during
installation.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE: We recommend
using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT:
If filler blocks
are not used, case
damage
may occur from over tightening
screws.
NOTE: When mounting the microwave oven, thread
power cord through hole in bottom of top cabinet.
Keep it tight throughout Steps 1-3. Do not pinch cord
or lift oven by pulling cord.
1.
Lift microwave,
tilt it
forward, and hook slots
at back bottom edge
onto four lower tabs of
mounting plate.
2, Rotate front of oven up
against cabinet bottom
3.
Insert a self-aligning
screw through top center
cabinet hole. Temporarily
secure the oven by
turning the screw at least two full turns after the
threads have engaged.
(It will be completely
tightened later.) Be sure to keep power cord
tight. Be careful not to pinch the cord,
especially
when mounting flush to bottom of
cabinet.
16
?7
;
:2
;/
;
: : ,
;"
:_
Advertisement
Table of Contents
