Connect Drain Hose; Connect The Inlet Hoses - Crosley CAWB527MQ2 Installation Instructions Manual

ConnectDrain Bose
Proper connection of the drain hoes protects your floors from
damage due to water leakage. Carefully reed and follow these
instructions.
The drain hose is connected to your washer and is stored inside
the washer cabinet.
Remove drain hose from washer cabinet
Gently pull the corrugated drain hose out of the washer from the
top of the hose. Continue to pull the hose until the end emerges.
Do not force excess drain hose back into the rear of the washer.
Laundrytub drain or standpipedrain
Connecting the drain hose form to the corrugated
drain hose
To prevent drain water from going back into the washen.
• Do not force excess drain hose into standpipe. Hose should
be secure but loose enough to provide a gap for ain
• Do not lay excess hose on the bottom of the laundry tub.
Roor drain
Do not install the drain hose form on to the corrugated drain hose.
You may need additional parts. See Floor Drain under "Tools and
Parts."
I.
Connect the Inlet Hoses
Insert new fiat weshem (supplied) into each end of the inlet
hoses. Firmly seat the washers in the couplings.
A B
A. Coupling
B. Washer
Connect the inlet hoses to the water faucets
Make sure the washer basket is empty.
2. Attach the hoes labeled hat to the hot water faucet. Screw
on coupling by hand until it is seated on the washer.
3. Attach the hose labeled cold to the cold water faucet. Screw
on coupling by hand until it is seated on the washer.
4. Using pliers, tighten the couplings with an additional
two-thirds turn.
A B
A. Snap either end of the drain hose form to the drain hose at the
point where the corrugation begins.
B. Bend drain hose ever drain hose form and snap into place.
7-1ghten t he couplings with an additionaltwo-thirds turn.
NOTE: Do not overtightan or use tape or sealants on the
valve. Damage to the valves can result.
6