Advertisement
Available languages
Available languages
White Wire
(Neutral)
Cablefrom
Residence
Wires 1
Box
(Neut_l)
Green
U.L.-listed
(or RareCopper)
Conduit
Wire
Cablefrom
Connector
Range
(or CSAlisted)
Figure 5
3-Wire (Grounded
Neutral) Electrical System
(example: Junction Box)
Where
local codes DO NOT permit
connecting
the
appliance
grounding
conductor
to the
neutral
(white)
wire or if connecting
to 4-wire
electrical
system (see Figure 6).
1. Disconnect the power supply.
2. Separate the green (or bare copper) and white
appliance cable wires.
3. In the circuit breaker, fuse box or junction box:
a) Connect the white appliance cable wire to the
neutral (white) wire.
b) Connect the 2 black wires together.
c) Connect the 2 red wires together.
d) Connect the green (or bare copper) grounding
wire to the grounding wire of the circuit breaker,
fuse box or junction box.
Cablefrom
Green
Residence
(or BareCopper)
Wire
Red_
rwir
Junction
Box
(or Bare Copper)
Wire
Cable from
Conduit
Appliance
Connector
(or CSA listed)
Figure
6
4-Wire
Electrical
System
(example:
Junction
Box)
Junction
Box Location
Locate junction box as shown in Figure 7.
If a service cord is used, the wall receptacle should be
located in accordance with the dimensions below.
7" Max.
(17.8cm
Max
Center
Line of
Range
$25.4
cm)
(so!O.cm)
_-
.wALL
"_
Center
Line of
Locate Electrical Hook-up
Range
Inside Shaded Area
Figure 7
Range
Placement
To eliminate the risk of burns or fire by
reaching over heated surface units, cabinet storage
space located above the range should be avoided. If
cabinet storage space is to be provided, the risk can be
reduced by installing a range hood that projects
horizontally a minimum of 5" (12.7 cm) beyond the
bottom of the cabinet.
Center
Line of
Range
Follow instructions for
the type of installation
you have
Figure 8
If range will be installed with a cabinet on both
sides, draw a center line on the floor between the
cabinets (see figure 8). If back of range will not be
flush with the wall (the location of the outlet may not
allow the range to be positioned against the wall), draw
a line on the floor where the back edge of the range will
be. Now install anti-tip brackets (see "Anti-Tip Brackets
Installation",
page 10).
If range will be installed with a cabinet on one side
only, move the range into final position. Draw a line on
the floor along the side of the range that is not against
5
Advertisement
