Advertisement
Available languages
Available languages
2.
Install
Anti-Tip
Bracket(s).
(See instructions on
page 4.)
3.
Serial
Plate
Information
The serial plate is located on the fl-ame and is visible
when the drawer is opened.
See the serial plate for the following
information:
A,Model,
lot and serial number of range.
B, Kilowatt rating (power requirements),
C,Voltage ratings,
4.
Electrical
Connection
Requirements
This appliance must be properly installed and grounded
by a qualified technician in accordance with the National
Electrical Code ANSI/NFPA No, 70--latest
edition--and
local electrical code requirements.
This
appliance
may
be connected
by means
of
permanent "Hard Wiring" or "Power Supply Cord Kit."
When hard wiring,
do not leave excess wire in range
compartment.
Excess wire in the range compartment
may not allow the access cover to be replaced properly,
and could create a potential
electrical
hazard if wires
become pinched.
Connect
only as instructed
under
"WIRING INSTRUCTIONS" in sections 6 and 7. When
using flexible conduit or range cable, use flex connector
or range cable strain relief,
NOTE: Only use copper wire in connection
to terminal
block,
4B. Models
Requiring Power Supply Cord Kit
U.$, STYLE
Figure 1 - 3-Wire Cord Kit
_RISK
OF FIRE OR ELECTRICAL SHOCK
MAY OCCUR IF AN INCORRECT SIZE RANGE CORD KIT
IS USED, THE INSTALLATION INSTRUCTIONS ARE NOT
FOLLOWED OR STRAIN RELIEFBRACKET IS DISCARDED.
This appliance may be connected
by means of a power
supply cord. Only a power supply cord kit rated at 40
amperes, 125/250 volts minimum,
and marked for use
with ranges shall be used, Cord must have three (3)
conductors,
Terminals on end of wires must be either
closed loop or open-end spade lugs with upturned ends.
Cord must have strain relief clamp,
NOTE: MOBILE HOME
INSTALLATION
OR AREAS
WHERE LOCAL CODES DO NOT PERMIT GROUNDING
THROUGH
NEUTRAL,
A FOUR
(4) CONDUCTOR
POWER CORD MUST BE USED.
A 1-3/8" knock-out hole is provided at the bottom of the
range terminal box for connecting the power supply cord
kit to the range terminal block (see Figures 2 and 3).
5. Permanent
Hard Wiring
(3 or 4 Wires)
Insert the residence 3-wire power supply cable through
the 1-1/8" hole at the bottom of the range terminal box
(see Figure 2). For mobile home application
or where
connections
with a 3-wire
power supply cable is not
allowed,
use a 4-wire
power
supply
cable
(for
connections,
see Figure 3), Use a U,L. approved
strain
relief clamp to secure the cable to the terminal box,
6. Wiring Instructions
- 3-Wire Supply Cable
_ELECTRICAL
GROUND IS REQUIRED ON
THIS APPLIANCE,
This appliance is manufactured
with the neutral terminal
connected to the frame. If local codes permit connection
of the frame grounding conductor
to the neutral wire of
the copper power supply cord:
Advertisement
