Advertisement
Installation
Instructions
[]
MOBILE OR MANUFACTURED
HOME
INSTALLATION
• Installation must conform to the MANUFACTUREDHOME
CONSTRUCTION & SAFETY STANDARD, T ITLE24, PART :32-80
or, when such standard is not applicable, with AMERICAN
NATIONAL STANDARDFOR MOBILE HOME,ANSI/NFPA NO.
50lB.
• The dryer MUST be vented to the outdoors with the
termination
securely
fastened
to
the
mobile
home
structure. (See EXHAUSTINFORMATION section 6).
• The vent MUST NOT be terminated beneath a mobile or
manufactured home.
• The vent duct material MUST BE METAL.
• KIT 14-D346-33 MUSTbe used to attach the dryer securely
to the structure.
• The vent MUST NOT be connected to any other duct, vent,
or chimney.
• Do not use sheet metal screws or other fastening devices
which extend into the interior of the exhaust vent.
• Provide an opening with a free area of at least 25 sq. in. for
introduction of outside air into the dryer room.
• Stacking of a gas dryer is not permitted in a mobile home
or manufactured home.
I_l GARAGE INSTALLATION
(IF ALLOWED
BY LOCAL CODES)
• Dryers installed in garages must be elevated 18 inches
(46cm) above the floor.
[] DRYER EXHAUST TO BOTTOM
CABINET
-ZiWARNING-BEFORE P ERFORMING
THIS EXHAUST INSTALLATION, BE SURE
TO DISCONNECT
THE DRYER FROM
ITS
ELECTRICAL SUPPLY. PROTECT YOUR
HANDS AND ARMS
FROM
SHARP EDGES
WHEN
WORKING
INSIDE THE CABINET.
BE SURE TO WEAR
GLOVES.
REMOVE
SCREW
AND SAVE,
(:_'\REMOVEBOTFOM
KNOCKOUT
Detach and remove the bottom knockout. Remove the
screw inside the dryer exhaust duct and save. Pull the duct
out of the dryer. Protect sharp edges around the knockout
and exhaust opening with the tape.
FIXING H OLE s
14
"
Cut the duct as shown and keep portion A.
TAB LOCATION
BEND TAB
UP45°
Through the rear opening, locate the tab in the middle of
the appliance base. Lift the tab to about 450 using a flat
blade screwdriver.
ADDING NEW DUCT
FIXING
HOLE
PORTION "A"
BOTTOM
EXHAUST
Reconnect the cut portion (A)of the duct to the blower
housing. Make sure that the fixing hole is aligned with the
tab in the base. Use the screw saved previously to secure
the duct in place through the tab on the appliance base.
ADDING ELBOW FOR EXHAUST
THROUGH BOTTOM OF CABINET
• Insert 4" elbow through the bottom opening, orient it for
bottom exhaust and connect it to the dryer internal duct.
CAUTIO N:Internal
duct
joints mustbesecured w ith tape,
otherwise they may separate and
cause a safety hazard.
DUCT
• Apply duct tape on the joint between the dryer internal
duct and elbow.
Advertisement
