GE PVM2070 Installation Instructions Manual page 12

Installation Instructions
OUTSIDE TOP EXHAUST
(Vertical Duct)
INSTALLATION OVERVIEW
A1. Attach Mom_ting Plate to _\'all
A2. Prepare Top Cabinet
A3. Check Damper Operation
A4, Mom_t Microwave Oven
A5. A(!just Exhaust Adaptor ',
A6. Connect Ductwork "
I-_ ATTACH THE MOUNTING
PLATE TO THE WALL
Attach tile plate to tile wall using toggle bolts.
At least one wood screw nlust be used to attach
the plate to a wall stud.
[]Remove the toggle wings fl'om the bolts.
[]Insert tile bolts into tile mounting plate
through the holes designated to go into drywall
and reattach the toggle wings to '_A"onto each bolt.
To use toggle bolts:
Mounting
Plate :_
Spacingfor Toggles
MoreThanWall
÷l_,.i-_Th
ckness
ToggleWings
Bolt End
[]Place tile mounting plate against tile wall and
insert tile toggle wings into tile holes in tile wall
to mount tile plate.
NOTE: Betore tightening toggle bolts and wood
scre_, make sure tile tabs on tile mounting plate
touch tile bottom of tile cabinet when pushed
flush against the wall and that the plate is properly
centered under the cabinet.
CAUTION: Be careflfl to axoid Ilinchin'*_ fingers
between the back of the motmting plate and the wall.
_ Tighten all bolts. Pull the plate awax from the wall
to help tighten the bolts.
12