Related Manuals for Monogram ZFGB21HZBSS
Summary of Contents for Monogram ZFGB21HZBSS
- Page 1 Installation Instructions Stoinless Steel Free-Stonding, Drower Freezer Refrigerotor PO07 monogram.corn...
-
Page 2: Table Of Contents
Product failure due to improper installation is not Les r6parations doivent 6tre faites par un technicien covered under the GE Appliance Warranty. qualifi& See the Owner's Manual for warranty information. For Monogram local service in your area, call 1.800.444.1845. -
Page 3: Product Dimensions And Clearances
. The cold water line can enter the opening through the 70" min. floor or through an adjacent cabinet, as close to the back wall as possible. The water line should be GE SmartConnect Refrigerator Tubing or 1/4" O.D.copper Water Supply tubing between the cold water line and water connection location at the rear of the refrigerator. - Page 4 Installation Instructions FLOORI NG TOOLS REQUIRED . Adjustable wrench For proper installation, this refrigerator must be placed on .3/8" and 5/15" socket ratchet/driver a level surface of hard material that is at the same height . Phillips head screwdriver as the rest of the flooring. This surface should be strong .3/32", !/8", !/4"...
-
Page 5: Installation Instructions
Installation Instructions WARNING iSTEP 2i LOCATE ANTI-TIP BRACKET A. Place the anti-tip floor bracket Iocutor template (included inside the anti-tip kit) onto the floor up against the rear wall, within W, and in line with the desired location of the RH side of the refrigerator (see Figure !). -
Page 6: Step 2, Install Anti-Tip Bracket
Installation Instructions ISTEP 2AJ LOCATE ANTI-TIP FLOOR STEP 2B INSTALL ANTI-TIP BRACKET BRACKET {CONT.) {CONT.) CONCRETEWall and Floor Construction: Figure 2- Acce.ptable Screw Placement Locations A. Anchors required (not provided): 4 each 1/4" x 1 1/2" lag bolts PreferredInstallation- PreferredInstallation- /4each 1/2"... -
Page 7: Step 4, Remove The Freezer Drawers
Installation Instructions STEP [STEP 31 INSTALL THE REFRIGERATOR 41 REMOVE THE FREEZER DRAWERS BEFORE MOVING REFRIGERATOR The freezer drawers can be removed, if needed, INDOORS to fit through tight areas. Readthese instructions completely and carefiJIly. IMPORTANT: Doors and passageways TOP DRAWER into the installation location require a 3Z"... -
Page 8: Step5 Remove The Fresh Food Doors
Installation Instructions STEP 4 REMOVE THE FREEZER STEP5 REMOVE THE FRESH DRAWERS (CONT.) FOOD DOORS BOTTOM DRAWER The top cap must be removed to access hinges. It is best to remove one door at a time. REMOVETHE 2-PIECE BASKET A. Remove 2 screws on top and 2 screws at the back A. -
Page 9: Step 6 Remove The Toekick
Installation Instructions ISTEP 81 REPLACE THE FREEZER STEP 6 REMOVE THE TOEKICK DRAWERS CCONT.} If, ofter removing the freezer drowers ond refrigerotor door, the refrigerotor will still B. Drive the bottom outside screw into the door not fit through o doorwoy, the toekick on eoch side until it is oll the wo U in. - Page 10 Installation Instructions STEP 81 REPLACE THE FREEZER [STEP 8] REPLACE THE FREEZER DRAWERS (CONT.) DRAWERS (CONT.) BOTTOM DRAWER REPLACE THE 2-PIECE BASKET: ATTACH AND SECURE THE BOTTOM DRAWER THE SLIDES Placethe rearofthe basket onto the metal slide brackets.There will be 2 pins Pull out the rail assemblies to the full on each underside of the back that will...
-
Page 11: Step 9, Replace Fresh Food Doors
NOTE:The only GE approved plastic tubing is supplied C. Insert the top hinge pin into the hinge hole on in GE SmartConnect '° Refrigerator Tubing kits. Do not top of the refriger(]tor door. H(]ke sure the door is use any other plastic water supply line because the line (]ligned with the cabinet (]nd opposite door. -
Page 12: Step Ioa, Rowater Line
Customers in Canada should consult the yellow pages Hold the tubing in place and tighten the fitting. for the nearest Mabe Service Center. If you are using GE SmartConnect '° tubing: Insert the molded end of the tubing into the refrigerator connection, at the back of the refrigerator, and tighten the compression nut until it is hand tight. -
Page 13: Step 1/4,Level Refrigerator
Installation Instructions STEP 14 LEVEL THE REFRIGERATOR STEP 15] LEVEL THE DOORS If the doors are not evenlu aligned at the top, Adjust the Rollers the refrigerator door can be adjusted. The refrigerator can be leveled by adjusting the rollers, . -
Page 14: Step 16, Install Toekick
Installation Instructions ISTEP 161 INSTALL TOEKICK [STEP 181 TEMPERATURE CONTROLS , Press toekick into position and reinstall one screw on , The temperature controls are preset at 37°F each side. for the refrigerator and 0°F for the freezer. , Allow 24 hours to stabilize before making adjustments. Toekick Screw I M PO RTANT:... - Page 15 Notes...
- Page 16 For Monogram _ local service in your area, call 1.800.444.1845. NOTE: Product improvement is a continuing endeavor at General Electric. Therefore, materials, appearance and specifications are subject to change without notice. GE Consumer & Industrial 31-46547 Appliances General Electric Compong...