Table of Contents
Related Manuals for Monogram ZFSB25D SS
Summary of Contents for Monogram ZFSB25D SS
- Page 1 Installation Instructions If you have questions, call 800.GE-CARES or visit our website at: www.monogram.com Free-Standing Side-by-Side Stainless Steel Refrigerator ZFSB25D SS ZFSB26D SS Monogram. ® We bring good things to life.
-
Page 2: Table Of Contents
GE Appliance Warranty. See the Owner’s • Les réparations doivent être faites par un Manual for warranty information. technicien qualifié. For Monogram local service in your area, 1-800-444-1845. For Monogram service in Canada 1-888-880-3030 For Monogram Parts and Accessories, call 1-800-626-2002. -
Page 3: Planning Information
The opening must be prepared with the electrical and Including Handles water supply located as shown. This Monogram free-standing refrigerator requires Additional Specifications the following clearances for proper air circulation, • A 115 volt 60Hz., 15 or 20 amp power supply is plumbing and electrical connections. -
Page 4: Installation Instructions
Installation Instructions TOOLS REQUIRED FLOORING For proper installation, this refrigerator must be placed • Tinsnips to cut banding on a level surface of hard material that is at the same • Stepladder • Bucket height as the rest of the flooring. This surface should be •... -
Page 5: Step 1 Move Refrigerator Indoors
Installation Instructions REMOVE THE DOORS STEP 1 MOVE REFRIGERATOR INDOORS The top cap must be removed to access hinges. It is best to remove one door at a time. A. Remove two screws on top of the refrigerator, one on IMPORTANT: Door and passageways into each side. -
Page 6: Step 2 Install Water Line
Installation Instructions REINSTALL DOORS STEP 1 (continued) Refer to the illustration on page 5. • Carefully, route the water line tubing and electrical To move the refrigerator indoors: through the freezer side bottom hinge. Lower the • Place a piece of the carton or soft cloth against the door onto bottom hinge. -
Page 7: Step 2A, Ro Water Line
Installation Instructions Step 2A WATER LINE STEP 3 CONNECT WATER SUPPLY INSTALLATION WITH A REVERSE OSMOSIS SYSTEM Check to be sure that refrigerator power cord is not plugged into the wall outlet. Skip this step when not using RO System 1/4"... -
Page 8: Step 6, Level Refrigerator
Installation Instructions STEP 6 LEVEL THE REFRIGERATOR STEP 7 LEVEL THE DOORS The refrigerator can be leveled by adjusting the rollers If the doors are not evenly aligned at the top, the located near the bottom hinges. refrigerator door can be adjusted. •... -
Page 9: Step 8 Start Icemaker
Installation Instructions STEP 9 TEMPERATURE STEP 8 START ICEMAKER CONTROLS • The temperature controls are preset at 37° for the Power Switch refrigerator and 0°F for the freezer. • Allow 24 hours to stabilize before making adjustments. STEP 10 INSTALL TOEKICK Feeler Arm •... - Page 10 Notes...
- Page 11 Notes...
- Page 12 Note: While performing installations described in this book, safety glasses or goggles should be worn. ® For Monogram local service in your area, call 1-800-444-1845. Note: Product improvement is a continuing endeavor at General Electric. Therefore, materials, appearance and specifications are subject to change without notice.